Home

Barclay Products 4118-60-ORB Installation Guide

1. Corner an Shower Rod BARCLAY INSTALLATION INSTRUCTIONS Parts Included e 1 Corner curved section rod 26 or 48 long 121 C or 123 C e 1 Straight Rod 60 66 or 78 long 121 S or 123 S e 2 300 Flanges 8 Wood Screws 2 Set Screws Tools Needed e Pencil Level Drill e Pipe Cutter Hacksaw ih 1 Determine the height at which you want to install the rod This should be approximately 6 3 from the inside bottom of your tub Mark the position of the flanges on the wall and the position of the holes to be drilled 2 Your rod is furnished in two pieces a corner section and a straight section You will note that the corner rod has a female thread on the short end and that the straight rod has a male thread on the end Connect the two sections together by turning until hand tight Do Not use any tools to tighten 3 Before proceeding any further hold the rod up in approximate position to make sure that the rod is not too long This rod is furnished long enough to fit most tubs and may have to be shortened If rod is too long cut off excess length from end without bushing using a hacksaw Rough edges left will be covered by the flange Do not cut the rod too short 4 Slip the flanges over each end of the rod and tighten the set screw on one flange to prevent it from falling off Fasten the other flange to the wall using the wood screws provided Loosen the set screw on the other flange and f
2. asten it to the wall After fastening flanges to the wall tighten the set screws on the flanges 3 23 12 P 847 244 1234 www barclayproducts com

Barclay Products 4118-60-ORB Installation Guide

Contents

Download Pdf Manuals

Related Search

Related Contents