Croydex WA972622YW Installation Guide
Contents
1. croydex Refreshing Bathroom Ideas Thank you for purchasing this Croydex product Please follow the fixing and care instructions to ensure that your bathroom product is fitted safely and that it retains its high quality finish Please retain this leaflet for future reference This instruction leaflet applies to the following products WA971022 MAINE MIRROR WA971122 MAINE TOILET ROLL HOLDER WA971422 MAINE SHELF WA971522 MAINE TOWEL RING WA971722 MAINE ROBE HOOK WA971822 MAINE TUMBLER HOLDER WA971922 MAINE SOAP DISH WA972422 MAINE TOILET BRUSH HOLDER Not wall mounted WA972622 MAINE SINGLE TOWEL RAIL Fixing Pack Contents and Wall Bracket Fixing screws x 2 Wall plugs x 2 D SASS N35 T Fixing template x 1 x2 x2 Tools Required Drill 6mm masonry drill bit 6mm ceramic drill bit optional Cross head screwdriver Pencil Spirit level Tape measure KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN Home Safety Advice Always take care when using an electric drill particularly in the bathroom Always check for hidden cables and pipework before drilling and take extreme care if there is any water in the working area Always wear suitable eye protection when drilling If the product is to be fitted on a ceramic tiled wall a ceramic drill bit should be used Always ensure that the drill hole passes through the central tiled area rather than through the grouted area To prevent uneccessary damage to the tile mask the area ar2. or chemical cleaners as these will damage the product Do not place hot objects onto the surface of the shelf For details of the other items in the Croydex range please visit our website www croydex co uk Croydex Limited Central Way Andover Hants SP10 5AW UK REVISION 2 SEPT 2006
3. ound the hole with tape before drilling Do not strike the product with hard or sharp objects Do not overload the shelf Maximum safe working load is 2 5kg evenly distributed if mounted on to a solid wall If mounted on to a cavity wall reduce the load to 2kg evenly distributed Accessories Fitting Instructions 1 Select position of product and mark centre of mounting holes on wall using the template supplied It is important to ensure that the hole centres are horizontal Check measurement against product before drilling 2 Using a6mm masonry drill drill the holes in marked positions to a depth of 50mm If drilling through tiles please pre drill using a ceramic drill bit 3 Insert the wall plugs to the surface of the wall If fitting to a tiled surface the wall plug should be inserted below the surface of the tile to avoid cracking 4 Screw the screws into the wall plugs leaving the screw head protruding by approximately 3mm see Fig 1 NA Wall plug Screw T Wall Fig 1 5 Align the keyhole fixings on the rear of the product see Fig 2 with the protruding screws and push down firmly to ensure the product locates tightly against the wall If adjustment is required remove the product and either loosen or tighten the screws until the product is held firmly in place Product Care To retain the best quality finish clean product regularly with a soft cloth and mild detergents Do not use abrasive
Download Pdf Manuals
Related Search