Yosemite Home Decor CANOPY REMOTE Instructions / Assembly
Contents
1. GENERAL INFORMATION This remote control is designed to separately control your ceiling fan speed and light brightness There are four buttons Hi Mid Low Off to control the fan speed and off The light button will control the light brightness and off The red indicator on the transmitter will light when the button is pressed INSTALLATION AND OPERATING INSTRUCTION 1 SETTING THE CODE This unit has 16 different code combinations To set the code perform these steps A Setting the code on the transmitter a Remove battery cover Press firmly below arrow and slide battery cover off b Slide code switches to your choice of up or down position Factory setting is all up Do not use this position Use a small screwdriver or a bail point pen to stide firmly up or down Figure1 B Setting the code on the receiver a slide code switches to the same positions as set on your transmitter Figure2 b Replace battery cover on transmitter 2 INSTALLING RECEIVER IN CEILING FAN A Safety precautions WARNING HIGH VOLTAGE Disconnect source of electrical power by removing fuse or switching off main circuit breaker e Do not use with solid state fans Electrical wiring must meet all local and national electrical code requirements Electrical source and fan must be 115 120 volt 60 Hz Maximum fan motor amps 1 0 Maximum light watts 190 incandescent only Household electrical power can cause serious injury or death TRANSMI2. 30 feet away try placing the black antenna wire higher up through ceiling outside the junction box CAUTION Ceiling angle shall Not Exceed 30 Degrees For mounting controller Models AS 3DN
3. TTER RECEIVER Hyou are unfamiliar with electrical wiring please have this done by qualified licensed electrician B Installing receiver in fan ac a Remove electrical power from the circuit SUPPLY b Remove ceiling fan canopy fram the mounting bracket FIG 3 c Disconnect existing wiring between ceiling fan and supply at electrical junction box d Make connections as follows using the wire nuts supplied Connect GREEN YELLOW fan wire to BARE ground wire Connect BLACK Contre Unit wire to BLACK supply wire AC L Connect WHITE Control Unit wire to WHITE wire of supply AC N AS Connect WHITE Control Unit wire to MOTOR N to WHITE fan wire j WHITE BLACK RECEIVER BLUE BLACK Connect BLACK RED Contro Unit wire MOTOR L to BLACK RED fan wire Connect BLUE Control Unit wire FOR LIGHT to BLUE light wire e Push all connected wires up into junction box f Lay the black antenna wire on top of the receiver and put the receiver in the mounting bracket CAUTION 7 i s g Reinstall the canopy on the mounting bracket Do not use fan speed control in canopies where the h Restore electrical power mounting is not as described in Figure 4 of the installation instructions BARE GREEN 3 OPERATING TRANSMITTER A Install 9 volt battery included To prevent damage to transmitter Remove the battery if not use for long period B Store the transmitter away from excess heat or humidity C This
4. remote control unit is equipped with 16 code combinations To prevent possible interference from or to other remote units such as garage door openers car alarm or security system if you find that your fan and light kit go on and off without using your remote control simply change the combination code in your transmitter and receiver D Operation buttons on the panel of the transmitter HI key for fan high speed MED key for fan medium speed LOW key for fan tow speed OFF key for fan speed off key for light brightness and off The light function is controlled by pressing the Q key Hold key down to change the brightness gt Keep pressing the button in excess of 0 7 second it becomes dimmer the light varies cyclically in 0 8 second Tap key quickly to turn light off or on NOTICE Your ceiling fan and light kit assembly must meet the following requirements 1 Do not use with solid state fans 2 Electrical rating 120V 60Hz 3 5A MAX motor amps 1 0 MAX Light watts 190 incandescent only YOUR REMOTE NOW HAS FULL CONTROL OF THE FAN AND LIGHT 4 TROUBLE SHOOTING GUIDE 1 Fails to operate a Power to receiver b Receiver wired correctly c Fan manual speed control in highest position d Light kit switch turned on e Good battery in the transmitter f Code set at exact same positions in both transmitter and receiver 2 Won t operate at distance If transmitter operates fanlight kit when up close but not at
Download Pdf Manuals
Related Search