Aspects IDSR118SNSCT Installation Guide
Contents
1. 18 watt Wall Sconce Models 323911 amp IDSRI18SNSCT Safety Precautions Read all safety precautions and installation instructions carefully before Fluorescent Wall Mounted 120VAC 60Hz This fixture is designed for use in a 110 120VAC 60Hz fused circuit installing or servicing this fixture Failure to comply with these instructions could result in potentially fatal electric shock and or property damage It is recommended that a qualified electrician perform all wiring This Do not use on a dimming circuit To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper grounding there must be a separate ground wire green contact fixture must be wired in accordance with all national and local supply panel electrical codes Do not handle any energized fixture or attempt to energize any fixture between this fixture and the ground connection of your main power This fixture is intended to be used for general indoor lighting in dry or with wet hands or while standing on a wet or damp surface or in water ASSEMBLY INSTRUCTIONS 1 Preparing for installation damp locations only A Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture B Carefully remove the fixture from the carton and check that all parts are included as shown in figure below Be careful not to misplace2. anty American Fluorescent Corporation warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 3 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit 1 of 1 NF CE lighting your vision 8060660 R4
3. any of the screws or parts which are needed for installing the fixture 2 Wiring all wiring must take place inside junction box Caution Make sure power is off at fuse or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of the ballast power supply use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing A Secure gem bar 1 on the junction box not supplied with two screws 2 supplied B Make all wire connections to appropriate wire Secure with wire nuts supplied C The black wire from the fixture is connected to the black wire from power source D The white wire from the fixture is connected to the white neutral wire from power source E Tuck all connections neatly into junction box 3 Mounting A Thread screws 3 on gem bar 1 B Install back panel 5 over screws 3 and secure it with the two thumbnuts 4 Adjust the effective length of the fixture mounting screws as necessary C Install 18W GU24 lamp 8 supplied per label Insert lamp into lamp holder 9 and turn it counter clock wise until lamp snaps in place 4 Shade To install the shade 7 align the two holes on the diffuser with the two holes on the top of the back panel Secure shade with two screws 6 5 Restore power at fuse or circuit breaker box Limited Factory Warr
Download Pdf Manuals
Related Search