Sea Gull Lighting 31625-782 Installation Guide
Contents
1. Installation And Safety Instructions HC 1557 Sea Gull Lighting Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 090809 IMPORTANT SAFETY INSTRUCTIONS Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off Use of other manufacturers components will void warranty listing and create a potential safety hazard If you are unclear as to how to proceed contact a qualified electrician You don t need special tools to install this fixture Be sure to follow the steps in the order given Under no circumstances should a fixture be hung on house electrical wires nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system Read instructions carefully Save these instructions CLEANING MOUNTING To clean wipe fixture with a soft cloth Clean glass with a mild soap BAR A Do not use abrasive materials such as scouring pads or powders NUT B steel wool or abrasive paper QUTLET BOX J GREEN SCREWS gt f GROUNDING ORDERING PARTS NIPPLE C Keep this sheet for future reference and in case you need to order SCREW replacement parts Parts for this fixture can be ordered from place i i COLLAR E of purchase Be sure to use exact wording from illustration when i ord2. ering parts CANOPY H BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts mom lt SCREW COLLAR are included as shown in Figure 1 Be careful not to misplace any of RING G the screws or parts which are needed to install this fixture INSTALLATION IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX FIXTURE LOOP J STEP 1 Rotate arms M STEP 2 Secure mounting bar A to outlet box with outlet box screws not supplied Thread nut B on nipple C so that 3 threads are exposed above nut B Thread nipple C into mounting bar A and secure with nut B Thread screw collar E to nipple C STEP 3 Using 2 pairs of pliers or chain breaks open one link of chain K and connect it to the fixture loop J at the top of the fixture Do not twist STEP 4 Slide the screw collar ring G and canopy H in that order over chain K Open one link on the other end of the chain K and attach it to the screw collar E which has been mounted to the nipple C FIGURE 1 NOT INCLUDED BE SURE TO CLOSE ALL CHAIN LINKS COMPLETELY INSTALLATION continued HC 1557 STEP 5 A Use a listed wire connector to connect the fixture hot wire black wire or round and smooth tracer to the supply hot wire B Use a listed wire connector to connect the fixture common wire white wire or square and rigid to the supply common wire C Gently try to remove the wires from the c
3. onnector If you can remove the wires carefully re do the wiring connection STEP 6 GROUNDING INSTRUCTIONS Connect the supply ground wire fixture ground wire and mounting OUTLET BOX bar ground wire pre attached using the supplied wiring connector Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors BAR A STEP 7 NUT B GREEN After wires are connected tuck them carefully inside outlet box GROUNDING Raise canopy H against ceiling and thread the screw collar ring G SCREW D to the screw collar E SCREW STEP 8 COLLAR E Place glass L in socket cup l and secure by threading retaining ring N onto socket CANOPY H STEP 9 Install lamps not supplied ohh SCREW COLLAR RING G RETAINING RING N GLASS L SOCKET CUP I FIGURE 2 NOT INCLUDED
Download Pdf Manuals
Related Search