Fortress Railing Products 52504000 Installation Guide
Contents
1. 3 Strip the insulation back 1 2 from the 18 2 gauge wires 4 Feed wires through 1 hole Insert LED Surface Mount and the LED Surface Mount Light LED feed wires Using Light into hole Using a rubber mallet tap the light into the supplied waterproof wire nuts connect the wires the hole until the LED Surface Mount Light flange is flush Note Polarity must be maintained Always connect the with the deck surface same side of 18 2 gauge wire with the same polarity i e positive marked on the LED Surface Mount Light wires LED Surface Mount Light feed wires are 60 long Please visit www fortressaccents com for information on how to order additional accessories For technical assistance please email technicalhelp fortressrailing com Hours of Operation Monday through Friday 8 00 AM to 5 00 PM CST Phone 1 866 323 4766 Fax 972 644 3720 www fortressaccents com2. Installation Instructions pORTRESS FortressAccents LED Surface Mount Light cceanls Post Caps amp LED Lighting It is the responsibility of the installer to meet all code and safety requirements The installer should determine and implement the appropriate installation techniques for each situation The Fortress Company or its distributors shall not be held liable for improper or unsafe installations WARNING Risk of Electric Shock Install all luminaires 10 feet 3 05 m or more from a pool spa or fountain Required Materials 1 Forstner Bit Drill Wire Cutters Wire Strippers Rubber Mallet Pencil Eye Protection Installation of LED Surface Mount Light on surfaces with excessive foot traffic is not recommended 1 Run 18 2 gauge stranded outdoor wire available from 2 Drill a 1 hole Fortress recommends using a 1 FortressAccents please visit www fortressaccents com for Forstner bit available from FortressAccents please dealer locations by routing in close proximity to the visit www fortressaccents com for dealer locations a luminaire or fitting or next to a building structure such as a the desired location Avoid locations that fall directly house or deck Wire should not be buried Place the LED above stringers or other structural elements of the Surface Mount Light in the desired location LED Surface deck and wiring Mount Light should be placed a minimum of 12 above ground level with a pencil mark the center point
Download Pdf Manuals
Related Search