Minka Lavery 376-267-L Installation Guide
Contents
1. 2 re pxryrC D RCO i 4 eee Copper Ground CAUTION ATTENTION When handling the fixture do not apply pressure to the LEDs Hold the fixture by the back plate J or bracket F Replacing LED module Fig 3 entran a The LED module can be replaced by a qualified electrician ma without cutting of wire and without damage to any decorative element to which the fixture is attached See installation steps for more details Fig 3 Fig 3 a Shut off power Remove screws G glass holders H and glass shades G375 376 I b Remove the wire nuts located inside the fixture back plate to disconnect the LED module c Remove cover N on LED module L and screws M on bracket F Carefully remove the LED module L from bracket F d Reverse steps a c for installing the new LED module e Note The LED module should be provided by a specified supplier f For better heat dissipation the LED module L should be applied with thermal grease when re lamping IMPORTANT Fixture should be installed by a qualified electrician to ensure proper wiring and installation Dimmable with ELV and or LED compatible wall dimmer switches ET american c lLisTet us ere lighting Intertek association2. INSTALLATION INSTRUCTIONS FOR 375 6 267 L For Wall Mount Fixture WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEUR ee FIG Shut off power at the fuse box or circuit breaker box If Set A A 021 106D necessary remove the old fixture and mounting hardware Back plate 2 Carefully unpack your new fixture and lay out all the parts Green screw on a clear area Take care not to lose any small parts Mounting Screws 2 necessary for installation MOUNTING THE FIXTURE FIG 1 Secure mounting back plate C to junction box A using A junction boxes screws D Size 8 32 1 2 L The side of the mounting back plate marked GND must face out CONNECTING THE WIRES FIG 2 Hi 3 At this point connect the electrical wires as shown in Fig 2 ad making sure that all wire connectors B are secured If your outlet has a ground wire green or bare copper connect the fixtures ground wire to it Otherwise connect the fixture l s ground wire directly to the mounting plate C using the i 4 green screw provided After wires are connected tuck J them carefully inside the junction box i 4 Align the fixture s back plate J over the mounting back plate C and secure with screws E FINISHING THE INSTALLATION FIG 1 5 Carefully slide glass shades G375 376 I into the bracket F and secure the glass holders H to the bracket F with screws G Fig
Download Pdf Manuals
Related Search