Sea Gull Lighting 75330-825 Installation Guide
Contents
1. Na Installation And Safety Instructions HC 989 il li hbj Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to sta gu ig mg this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 021009 IMPORTANT SAFETY INSTRUCTIONS e Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off e Use of other manufacturers components will void warranty listing and create a potential safety hazard e If you are unclear as to how to proceed contact a qualified electrician e You don t need special tools to install this fixture QUTLET BOX OUTLET BOX e Be sure to follow the steps in the order given SCREWS e Read instructions carefully e Save these instructions f J MOUNTING T il BAR A FIXTURE MOUNTING SCREWS B NOTE FOR FIXTURES PROVIDED WITH 75 C OR 90 C SUPPLY WIRE WARNING ONLY THESE WARNINGS ARE PROVIDED ON THE LABEL AND ON THE FIXTURE CARTON RISK OF FIRE MOST DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60 C CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING SCREW H Sanne FIXTURE GRO Ht _CONNECTORS CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and i2. n case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when CAP NUTS J ordering parts CENTER PIPE E BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts are included as shown in Figure 1 Be careful not to misplace any of the screws or parts which are needed to install this fixture INSTALLATION IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX STEP 1 Thread fixture mounting screws B through mounting bar A Secure mounting bar A to outlet box with outlet box screws not supplied lt lt DIFFUSER G STEP 2 A Use a listed wire connector to connect the fixture hot wire black wire or round and smooth tracer to the supply hot wire B Use a listed wire connector to connect the fixture common wire white wire or square and rigid to the supply common wire C Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection FIGURE 1 NOT INCLUDED INSTALLATION continued HC 989 STEP 3 GROUNDING INSTRUCTIONS The green grounding screw H is to be inserted into the hole with two raised dimples provided on the mounting bar A Wrap the ground wire I from the fixture and the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw H on the mounting ba
3. r A and tighten the green grounding screw H to secure If uninsulated wire is on the mounting bar A connect the ground wire l from the fixture if supplied and the outlet box to it using a small wire connector not supplied NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors STEP 4 After wires are connected tuck them carefully inside outlet box Raise canopy C to the ceiling allowing for fixture mounting screws B to protrude through canopy C Secure in place by threading cap nuts J onto fixture mounting screws B STEP 5 Thread center pipe E into coupling D STEP 6 Install lamps STEP 7 Raise diffuser G and secure by threading finial G to center pipe E
Download Pdf Manuals
Related Search