Sea Gull Lighting 75474-962 Installation Guide
Contents
1. Na Installation And Safety Instructions HC 1455 il li hbj Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to sta gu ig mg this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 112508 IMPORTANT SAFETY INSTRUCTIONS e Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off e Use of other manufacturers components will void warranty listing and create a potential safety hazard e f you are unclear as to how to proceed contact a qualified electrician e You don t need special tools to install this fixture e Be sure to follow the steps in the order given e Read instructions carefully zs MOUNTING e Save these instructions BAR A FIXTURE MOUNTING NOTE FOR FIXTURES PROVIDED WITH 75 C OR 90 C SUPPLY WIRE FOUND ON CARTON LABEL WARNING ONLY RISK OF FIRE MOST WELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60 C CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING GROUNDING SCREW D CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap CANOPY E Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be2. ninsulated ground wire is on the mounting bar A connect the ground wire from the fixture and the outlet box to it using a small wire connector not supplied NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors After wires are connected tuck them carefully inside outlet box Raise the canopy E to the ceiling allowing for mounting screws I to protrude through key slots N Rotate canopy E clockwise until screws l are in narrow part of keyslot N Tighten screws I with screwdriver STEP 6 Install lamps STEP 7 Raise diffuser H to canopy so that bottom nipple protrudes through hole in diffuser H Secure in place by threading bottom lockwasher and hexnut C to diffuser H Raise decorative cup G so bottom nipple protrudes and secure by threading finial L to bottom nipple
3. sure to use exact wording from illustration when KEYSLOTS N ordering parts BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts are included as shown in Figure 1 Be careful not to misplace any of the screws or parts which are needed to install this fixture DIFFUSER H INSTALLATION BOTTOM NUT amp TD LOCKWASHER C IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX DECORATIVE TTS TF FINIAL Ll gt O Thread fixture mounting screws I into threaded holes of mounting bar A 3 turns each STEP 2 Secure mounting bar A to outlet box with outlet box screws not supplied Raised side is top as illustrated FIGURE 1 NOT SUPPLIED INSTALLATION continued HC 1455 STEP 3 A Use a listed wire connector to connect the fixture hot wire black wire or round and smooth tracer to the supply hot wire B Use a listed wire connector to connect the fixture common wire white wire or square and rigid to the supply common wire C Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection GROUNDING INSTRUCTIONS The green grounding screw D is to be inserted into the hole with two raised dimples provided on the mounting bar A Wrap the ground wire from the fixture and the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw D on the mounting bar A If u
Download Pdf Manuals
Related Search