Frame It All 300001062 Instructions / Assembly
Contents
1. inch Joints Installation cp G Stacking Joint Bracket _ Stacking Joint Preparing for installation Slide one end of a timber into the channel end of one of the brackets See Image 1 so that the edge of the bracket is flush with the lower concave edge of the composite timber See Image 2 and below the upper convex edge See image 3 Carefully screw the bracket in place using the screws supplied with a power drill or screwdriver Be careful not over tighten the screws Repeat this process on the oppo site end of the timber flipping the bracket in the opposite direction See Image 4 Repeat for all timbers The Stacking Joint Contains e 2 Stakes e 4 Brackets e 2 Caps e 8 Screws Bracket Tools Required Hammer or Mallet Power Drill or Screwdriver Installing Your Frame Select the desired location of your raised garden lay out the timbers to the desired design then insert a Joint Stake through each of the corner brackets and hammer the stake into the soil See Image 5 You can locate your raised garden on a cement surface by simply removing the spike from each of the Joint Stakes with a hacksaw to allow them to rest on a hard surface Stacking Additional Levels f a multi level design is desired slide a stacking stake into all of the exposed tops of level 1 stakes and put the level 2 timbers in place until level 2 is complete See Image 6 You can continue stacking additional le2. vels until reaching your desired height Finish To finish the appearance of each joint and to secure the brackets over the stake push or tap the supplied caps into the tops of the stakes until they snap in place Image 1 Image 5 Image 2 Image 6
Download Pdf Manuals
Related Search