Perfect Water Technologies ISet-TMA-HGP Use and Care Manual
Contents
1. HydroGardener Reverse Osmosis System Filter Change Instructions system damage Water should now be flowing through the system to the point of use Allow the water to run until the stream falls to a thin gentle flow Initial discharge may be accompanied by a harmless discoloration due to loose carbon Discard the first few gallons of product water until the water runs clear and both the TDS and pH stabilize For more information please visit www ThePerfectWater com or contact customer service at 1 877 693 PURE We will be happy to assist you with your filter change Insert tube Push up to tube stop Push in collet and remove tube Push the tube into the fitting to the tube stop The collet gripper has To disconnect ensure the system is depressurized before removing the tube stainless steel teeth which hold the tube firmly in position while the O ring Push in collet squarely against face of fitting With the collet held in this provides a permanent leak proof seal position the tube can be removed Pull to check secure Pull on the tube to check that it is secure It is a good practice to test the system prior to leaving site and or before use Perfect Water Technologies Inc Copryright 2010 THE PERFECT Waren COM Page 4 Customer Service Hotline 1 877 693 PURE Perfect Water Technologies HydroGardener Series Reverse Osmosis System Filter Change Instructions Customer Service Hotline 1 877 693 PU2. RE HydroGardener Reverse Osmosis System Filter Change HydroGardener Series Reverse Osmosis System Filter Change Instructions Tools Required Scissors Towel 1 Clear away a workspace near the location of the HydroGardener Reverse Osmosis System 2 Turn off the water feeding the HydroGardener by closing the inline ball valve located on the feed water line See Figure 1 3 Depressurize the system Locate the 3 8 blue tubing at the output of the system Depending on how you have terminated this line and connected it to your point of use float valve ball valve open to reservoir make sure this is open and water no longer flows The system is now depressurized continue to leave it in the open position 4 Slowly and gently pull the HydroGardener off of its mounting clips from the bottom up Lay it on a towel Pull off the first filter to be changed IMPORTANT Make note of flow direction arrows on the filter body and line then up with the replacement filter which you should position nearby Page 2 Customer Service Hotline 1 877 693 PURE HydroGardener Reverse Osmosis System Filter Change To determine which replacement filter you Should use compare the labels on the filters and make sure the flow direction arrows face the Same direction Make note of your system configuration To remove the tubing from the filter push down the seal ring to the filter body with the thumb and forefinger w
3. hile simultaneously pulling on the tubing as shown in Figure 6 Some mild resistance to pulling out the tubing is normal Removing the tubing will be impossible without first fully depressurized the HydroGardener as described in step 4 See diagram on page 4 Immediately trim off a 1 4 from the end of the tubing with the scissors Make sure tubing end is smooth and round before inserting it into the replacement filter NOTE A rough or oblong tube end will leak Insert the tube end about a 1 4 into the replacement filter fitting then pull back gently to ensure a sung fit Repeat step 4 for the other end of the filter Immediately discard used filter Repeat step 4 for each of the next replacement filters Remount the HydroGardener and SLOWLY open the feed water line to the HydroGardener Failure to repressurize slowly may result in Page 3 Customer Service Hotline 1 877 693 PURE
Download Pdf Manuals
Related Search