American Standard 7381422-100.0070A Installation Guide
Contents
1. the tank with one hand e Place friction washer over threads on the bottom of the tank FIGURE 5 e Attach nut FIGURE 6 for orientation tabs must face further away from tank e Use supplied tool to tighten nuts to tank one hand tight e Apply and work the gaskets around the 6 retaining tabs on the nut so the inner rib on the gasket is captured between the tabs and the tank Note the inner rib on the gasket is offset to one side Be sure to orient the gasket with the inner rib towards the tank When done correctly the gasket should not be compressed and should be held in place while installing the tank e Re mount tank to bowl e Reattach refill tube clip onto the overflow tube of the new valve hose should direct water into overflow tube e Insert the trip lever arm in to the yoke FIGURE 3 e Push the clevis pin through the arm FIGURE 3 e Insert the hair pin FIGURE 3 FIGURE 6 FIGURE 5 www americanstandard us com vormaxparts Product names listed herein are trademarks of AS America Inc AS America Inc 2014 7302171 100 MULAN EEN VORMAX FLUSH VALVE ASSEMBLY PART NUMBER 7381422 100 0070A COMPLETE BY ADJUSTING THE SETTINGS e Depress trip lever handle all the way2. A e Adjust screw on the teeter bar B so rear frame C touches the frame stop D e Return trip lever handle A to rest position e Make sure hook E is fully engaged under tab on valve body F if not slightly adjust screw to make sure hook is engaged e Turn water supply on adjust water level to specified dimension on back of tank and flush 5 times to prime www americanstandard us com vormaxparts Product names listed herein are trademarks of AS America Inc AS America Inc 2014 7302171 100
3. MULAN EEN VORMAX FLUSH VALVE ASSEMBLY PART NUMBER 7381422 100 0070A e All trim components including tank to bowl gaskets washers nuts clevis pin and hair pin e Includes a nut tightening tool REMOVAL e Turn off water supply flush toilet remove all water from the tank e Remove tank nuts Do not remove 2nd set of tank nuts FIGURE 1 amp 2 e Remove tank from bowl amp lay tank on flat surface on backside to prevent scratching No need to remove trip lever e Remove hair pin FIGURE 3 e Remove clevis pin this frees the teeter bar from the trip lever arm FIGURE 3 e Remove the refill tube clip from the overflow tube e Grab and remove tank to bowl gaskets from the underside of the tank e Take the included tool and remove the tank to bowl nut counterclockwise e Remove friction washer e Remove flush valve assembly from the inside through the top of the tank FIGURE 1 DO NOT REMOVE NUTS FIGURE 2 mites ok FIGURE 3 www americanstandard us com vormaxparts Product names listed herein are trademarks of AS America Inc AS America Inc 2014 7302171 100 Mmentan EA VORMAX FLUSH VALVE ASSEMBLY PART NUMBER 7381422 100 0070A RE ASSEMBLY e Install the valve orient valve assembly so overflow tube is positioned towards the back of the tank FIGURE 4 e Hold the valve in
Download Pdf Manuals
Related Search