EcoSmart POU 6 Instructions / Assembly
Contents
1. VERIFY ALL VOLTAGE amp AMPERAGE INFO LISTED BELOW WITH THE ACTUAL LABEL SPECIFICATIONS ON YOUR UNIT WIRE GAUGE AND BREAKER SIZE CAN VARY BASED ON A NUMBER OF FACTORS INCLUDING SUPPLIED VOLTAGE AND LENGTH OF CIRCUIT CHECK LOCAL REQUIREMENTS MODEL Required breaber AWG ECO3 5POU ONE 30AMP 29AMPS 10 ECOSMART US LLC 3315 NW 167th Street Miami Gardens Florida 33056 WWW ECOSMARTUS COM Tel 305 623 7900 Fax 305 623 7923 Toll Free 877 474 6473 Page 3 POINMORUSE ECO SGMamAT GREEN ENERGY PRODUCTS e WORKS WITH LOW WATER PRESSURE e SAVE WATER AND ENERGY e INSTANT HOT WATER EASY INSTALLATION TANKLESS WATER HEATER NO TANK NO WAIT NO COMPARISON THE MOST ADVANCED TANKLESS WATER HEATER IN TODAY S MARKET IMPORTANT SAFETV INFORMATION As when installing or using anv high voltage electrical appliance basic safetv precautions should alwavs be followed Under no circumstances should vou attempt to clean install inspect repair disassemble 0r otherwise service this water heater without first shutting off all power to the unit directiv at the breaker box SERIOUS BODILV INJURV OR DEATH COULD OCCUR IF VOU IGNORE THIS WARNING FAILURE TO DO SO COULD CAUSE PROPERTY DAMAGE OR SERIOUS PERSONAL INJURY OR DEATH AND VOID YOUR WARRANTY THIS WATER HEATER MUST BE INSTALLEDBY A LICENSED ELECTRICIAN AND PLUMBER PROOF OF INSTALLATION MUST ACOMPANY THE WARRANTY C2. ARD PLEASE FOLLOW ALL RECOMMENDATIONS AND LOCAL CODE REQUIREMENTS FAILURE TO FOLLOW PROPER PROCEDURE IS HAZARDOUS IT CAN ALSO DAMAGE THE HEATER AND VOID THE WARRANTY TURN OFF ELECTRICAL SUPPLY MAIN AND WATER SUPPLY BEFORE ATTEMPTING ANY INSTALLATION DO NOT TURN ON ELECTRIC OR WATER SUPPLY UNTIL INSTALLATION IS PROPERLY COMPLETED e DONOTremove the heater cover open the unit or break the seal This could cause DEATH OR INJURY and will VOID THE WARRANTY DONOT Install Heater in a shower or any where it can bel reached or adjusted by anyone while using water DO NOT Operate the unit if water ceases to flow during use Contact technical support for this or any other issue of concern On the web at WWW ECOSMARTUS COM Call 305 623 7900 or 877 474 6473 Although installation is simple DO have a licensed Plumber amp Electrician perform the installation e COMPLY WITH LOCAL CODES AND PERMITTING Cold water Inlet Hot water outlet wire Setting Temp Display POWER KNOB amp Temp Controller Page 1 This water heater is supplied with 1 2 compression fittings Do not weld or use Teflon or paste Connect the cold water supply line to the right hand side Connect the hot water supply line to the left hand side Once both water lines are fastened and secured you must run water through the unit for at least 2 to 3 minutes to flush any air pockets purging in the lines it is recommended that
3. all faucets showers etc be run Failure to follow this step can cause permanent damage to the unit This proc edure MUST be performed before any electrical power is turned on COPPER RING COPPER NUT COPPER PIPE CIRCUIT BREAKER The electrical installation is based on the different Models Unit must be installed to independent breakers as per Model specs 1 click the power button and turn on the unit 2 reducing the flow rated thus increasing the outlet temperature Increasing the flow rate thus reducing the outlet temperature Page 2 4 4inches 8 9inches n HOW TO INSTALL 24 4 THE UNIT MUST NOT BE OPENED TO PERFORM THIS INSTALL OR WARRANTY WILL BE NULL AND VOID
Download Pdf Manuals
Related Search