Gronomics PP2 18-34 Instructions / Assembly
Contents
1. side rail Item 5 90 install the side rail into the upper wide part of the slot on the 4 x 4 x 80 corner post Item 22 and Slide down to the bottom of the slot Install one 14 1 2 x 2 1 2 narrow center side rail Item 3 and slide down Install one 14 1 2 x 5 1 2 side rail Item 5 and slide down East Bethel MN USA 163 753 7374 6 Side Rail Assembly Locate and install one 31 x 5 1 2 side rail w cleat Item 8 cleat facing down into the upper wide part of the slot on the two posts and slide down to the bot tom of the slot Install one 31 x 2 1 2 narrow center side rail Item 7 and slide down and one 31 x 5 1 2 side rail w Logo Item 10 and slide down Repeat step 4 6 for the second planter box www gronomics com Locate two 2 x 8 x 64 trusses Item 18 one pentagon cap Item 13 and one support plate Item 12 Place the pentagon cap on the ground face down Place the two trusses on the pentagon cap Adjust the trusses until centered left right and up down on the pentagon cap Place one bottom board Item 6 under each truss This will help level the trusses Place a support plate Item 12 onto the top of the two trusses Align the support plate with the top and bottom of each truss Verify that the two trusses are still contacting each other under the support plate ms j 4 od se oS oe ee ee Install ten 5 16 x 22. Repeat for second planter box Locate four 15 1 2 x 5 1 2 bottom boards Item 6 Install into the bottom of planter box Repeat for second planter box Locate the two pieces of fabric liner Item 1 Place one piece in the bottom of each planter box Soil Capacity 6 Cubic Feet www gronomics com East Bethel MN USA Locate the 29 x 52 trellis assemblies Item 20 Extend one trellis assembly Place the trellis assembly onto the top of the planter box and slide over until all the boards contact the 80 post This will help square up the trellis before installing Align the the top of the trellis on the center of the top side rail center the Align top of trellis on trellis left and right and fasten with six8 x center of side rail 1 1 2 screws Item 14 on top amp bottom of trellis Repeat this procedure on other side 163 753 7374
3. side rail w cleat Item 8 with cleat facing you into the upper wide part of the slot on the two posts Slide the side rail down to the bottom of the slot Install one 31 x 2 1 2 narrow center side rail Item 7 and slide down Install one 31 x 5 1 2 side rail Item 9 and slide down www gronomics com 5 Planter Box Assembly Locate one 4 x 4 x 32 corner post Item 11 and one 14 1 2 x 5 1 2 side rail Item 5 Place the post on the ground slots towards the top turn the post until one Slot is facing you and a second slot is facing to the right Slide the side rail into slot and slide to the bottom of the slot Rotate the 4 x 4 x 32 corner post Item 11 and the 14 1 2 x 5 1 2 side rail Item 5 90 install the side rail into the upper wide part of the slot on the 4 x 4 x 80 corner post Item 21 and Slide to the bottom of the slot Install one 14 1 2 x 2 1 2 narrow center side rail Item 3 and slide down Install one 14 1 2 x 5 1 2 side rail Item 5 and slide down Locate one 4 x 4 x 32 corner post Item 11 and one 14 1 2 x 5 1 2 side rail Item 5 Place the post on the ground slots towards the top turn the post until one Slot is facing you and a second slot is facing to the left Slide side rail into slot and slide to the bottom of the slot Rotate the 4 x 4 x 32 corner post Item 11 and the 14 1 2 x 5 1 2
4. 3 4 screws Item 15 Repeat procedure for second truss assembly East Bethel MN USA 163 753 7374 8 Planter Box Assembly Option Assembled Pergola Planter with planter boxes facing in Assembled Pergola Planter with planter boxes facing out Planter Boxes Facing In c a Planter Boxes Facing Out NOTE The pergola planter boxes can be assembled NOTE The pergola planter boxes can be assembled with the planter boxes facing in If assembling the with the planter boxes facing out If assembling the planter boxes facing in see steps 9 amp 10 planter boxes facing out see steps 11 amp 12 9 Planter Box Installation Facing In Place one truss assembly on the ground pentagon cap facing down Place one of the bottom boards Item 6 under each truss This will help level the trusses Place the planter box assemblies onto the truss assembly as shown Verify that the truss assembly is contacting the Angled Notch angled notch on both 80 posts The outside of the 4 x 4 x 80 post should be fw 7 approximately 11 from the end of the truss assembly Install two 5 16 x 2 3 4 Item 16 screws through the pre drilled holes in the 80 posts and into the truss assembly www gronomics com East Bethel MN USA 163 153 7374 40 Planter Box Installation Facing In Continued Place the second truss assembly on the top Pentagon Cap Facing Up Angled Notch of the planter box assemblies pen
5. 6 screws through the slot in the 80 post and into the truss assembly DS E a E A Tr Bis Taa ah taa li p ia a a Ai A Stand pergola up Locate one 31 x 5 1 2 side rail Item 9 Install the side rail into the slot on the two 80 posts securely fastening the two posts together Repeat on opposite side Locate the six 2 x 6 x 60 truss cross pieces Item 19 Place one truss cross piece notch down onto the truss assemblies 16 from the middle of the truss assembly Slide down until it contacts the 80 posts Install the next truss cross piece 32 from the middle of the truss assemblies Install the next truss cross piece 48 from the end of the truss assemblies Fasten each truss cross piece in place with one 10 x 4 deck screw Item 17 both sides When installing the deck screws tighten the screw unit it makes contact with the truss cross piece NOTE If the screw is installed too deep it may allow moisture to penetrate the wood and may cause damage to the structure Repeat procedure for opposite side of truss assemblies www gronomics com East Bethel MN USA 163 153 7374 Remove the rubber cap from the corner posts studs of the planter boxes Align the hole of the 4 x 4 post cap Item 2 with stud and tighten until the cap makes contact with the post Locate two 15 1 2 x 4 1 2 corner notched bottom boards Item 4 Place the two boards on each end of the planter box
6. GRONOMICS Pergola Planter 18 x 34 Assembly Instruction ITEM PP2 18 34 ITEM PP2 18 345 Remove contents from Box 1 of 3 Stack matching pieces in piles Using the parts list locate and count the individual pieces and verify that you have received the correct number of pieces If any pieces are missing or replacement parts are required contact Gronomics at 1 855 299 6727 NOTE It is recommended to place a protective layer between the ground and the pieces during assembly This will help prevent damage to the pieces Torx T30 Torx T25 Torx T15 OQ D 210 am ime ie Fabric Liner 22 x 36 2 4 3100 Post Cap 4 x 4 x 1 1 2 3 4 1451 Narrow Center Side Rail 14 1 2 x 2 1 2 x 1 4 4 1554 Corner Notched Bottom Board 15 1 2 x 4 1 2 x 1 5 8 1450 Side Rail 14 1 2 x 5 1 2 x 1 6 8 1550 Bottom Board 15 1 2 x 5 1 2 x 1 Narrow Center Side Rail 31 x 2 1 2 x 1 8g 4 3102 Side Rail w Cleat 31 x 5 1 2 x 1 9 4 3101 Side Rail 31 x 5 1 2 x 1 Side Rail w Logo 31 x 5 1 2 x 1 Corner Post 4 x 4 x 32 8 x 1 1 2 GRK Screw Trellis RSS 5 16 x 2 3 4 GRK Screw Support Plate 16 8 RSS516 234ZY RSS 5 16 x 2 3 4 GRK Screw Posts R4 10 x 4 GRK Screw Crosspieces into Trusses www gronomics com East Bethel MN USA 163 153 7374 Remove contents from B
7. ox 2 of 3 Stack matching pieces in piles Using the parts list locate and count the individual pieces and verify that you have received the correct number of pieces If any pieces are missing or replacement parts are required contact Gronomics at 1 855 299 6727 NOTE It is recommended to place a protective layer between the ground and the pieces during assembly This will help prevent damage to the pieces Box 2of3 ITEM PART DESCRIPTION 6100 Truss 2 x 8 x 64 19 6 6102 Truss Cross Piece 2 x 6 x 60 Remove contents from Box 3 of 3 Stack matching pieces in piles Using the parts list locate and count the individual pieces and verify that you have received the correct number of pieces If any pieces are missing or replacement parts are required contact Gronomics at 1 855 299 6727 NOTE It is recommended to place a protective layer between the ground and the pieces during assembly This will help prevent damage to the pieces Box 3of3 Trellis 29 x 52 Post LH 4 x 4 x 80 Post RH 4 x 4 x 80 www gronomics com East Bethel MN USA 163 753 7374 Locate one 4 x 4 x 80 corner post Item 21 marked with an X and one 4 x 4 x 80 corner post Item 22 marked with an O MONS Place the two posts flat on the ground with slots facing up and slots facing the inside Ensure that the notches face outward Locate and install one 31 x 5 1 2
8. tagon cap Angled Notch facing up Position the outside of the corner posts 7 INe 17 A approximately 11 from the end of the truss assembly Verify that the truss assembly is contacting the angled notch on both 80 posts Install two 5 16 x 2 3 4 Item 16 screws through the slot in the 80 post and into the truss assembly 11 Planter Box Installation Facing Out Place one truss assembly on the ground pentagon cap facing down Place one of the bottom boards Item 6 under each truss This will help level the trusses Place the planter box assemblies onto the truss assembly as shown Verify that the truss assembly is contacting the angled notch on both 80 posts Angled Notch The outside of the 4 x 4 x 80 post should be approximately 18 from the end of the truss assembly Install two 5 16 x 2 3 4 Item 16 screws aaa through the pre drilled holes in the 80 posts and into the truss assembly www gronomics com East Bethel MN USA 163 753 7374 12 Planter Box Installation Facing Out Continued Place the second truss assembly on the top Angled Notch Pentagon Cap Facing Up Angled Notch of the planter box assemblies pentagon cap facing up Position the outside of the 80 corner posts approximately 18 from the end of the truss assembly Verify that the truss assembly is contacting the angled notch on both 80 posts Install two 5 16 x 2 3 4 Item 1
Download Pdf Manuals
Related Search