ClosetMaid 21782 Installation Guide
Contents
1. Closet Rod End Cap Shelf End Cap 4 Corners Butt shelves A Be sure to allow for the width of the full length shelf when calculating the size of the other shelf Use a corner support to connect the two shelves Use a corner hanger bar to connect hanger bars and allow clothes to slide around corners Or use a corner kit B that includes a specially designed corner shelf corner hanger bar and all installation hardware NOTE Hanger bar supports should be placed where hanger bars join 5 Measuring and cutting shelves and hanger bars Wire shelving can be cut using a bolt cutter or hacksaw Hanger bars can be cut using a pipe cutter 6 Using 16 in shelving 16 in shelving provides additional storage capacity It is especially good for storage of linens or boxes and as shoe shelving Hanger bars can be installed using 16 in shelving When using 16 in shelving to hang clothes be sure to use 12 in support brackets as shown so the shelf is supported properly and hangers can slide unobstructed 7 Alternative hardware Support poles instead of support bracket when stacking two or more shelves EMERSON2. MCLOSETMAID Fixed Mount Installation Tips 1 Shelf installation There are three ways to install a shelf Wall to Wall Wall to Open Open to Open Shelves are supported by wall clips and support brackets or support poles When a shelf is attached to a side wall a wall bracket is also used Choose the right hardware based on the length of the shelf and whether or not it attaches to a side walll Open to Open Wall to Wall FN Wall to Open 2 Use the right hardware Drywall Use ClosetMaid hardware with attached anchor in drywall that is 5 8 in thick or less Drill 1 4 in hole insert hardware and push in pin using the blunt end of a hammer or screwdriver Punching the holes in the wall or drilling oversized holes will result in a weakened installation Hammering pins into the wall can result in broken hardware Wood studs Cut attached anchor off of ClosetMaid hardware and secure to the wall using a 8 x 1 in screw into the stud Concrete all and plaster or drywall over 5 8 in thick Drill 1 4 in hole insert hardware with attached anchor and secure to the wall using a 8 x 1 in screw 3 End caps Add caps to every exposed wire on both ends of each shelf and to the ends of closet rods End caps protect you your clothing and the shelving materials ClosetMaid com 1 800 874 0008 10 13 Choose Your Hardware Support Bracket EE Side Wall Bracket Wall Clip D Closet Rod Closet Rod Support
Download Pdf Manuals
Related Search