Triarch 31534 User's Manual
Contents
1.2. TI ASSEMBLY INSTRUCTION ITEM 31534 1 Remove center knock out in outlet box 2 Position wood support across ceiling joists over outlet and mark location for drilling a 9 16 dia Hole for the 1 4 18 nipple 3 After drilling Align wood support over outlet box and secure with nails 4 Install 10 long nipple through wood support and center hole in outler box with hex nuts and washers as shown Rod should extend through outlet box 1 1 2 minimum Tighten the two hex nuts above the wood support against each other to lock their position on the nipple caution do not tighten hex nuts at outlet box at this time leave loose until entire fixture weight is suspended 5 Thread loop to nipple 6 Install hex nut hickey 2 3 8 nipple onto end of support rod 7 Place canopy over the 2 3 8 nipple and screw collar loop onto the nipple the secure with the ring 8 Adjust chain to desired height Attach adjustable link to screw collar loop and to chain one end then Close the adjustable link 9 Attach adjustable link to chain at other end and to fixture loop then close the adjustable link 10 Allow ring and canopy to slide down chain Weave fixture wire and groud wire insert fixture wire and ground wire through center of screw collor loop Up through 2 3 8 nipple and out through hickey side opening 11 Connect the wire from the fixture to te power supply wire from outlet box Cover with wire connector A Twist together glossy wire from the fixture with white wire fr
3. om outlet box Cover with wire connector B Twist together rough wire from the fixture with black wire from outlet box Cover with wire connector C Twist together fixture ground wire with house ground wire Cover with wire connector 12 Place the canopy all the way to the ceiling and tight the ring onto the screw collar loop until the canopy is firmly held against the ceiling 13 Carefully unpack the glass shade from the box and set the glass shade onto the socket then install it into the frame 14 Install the bulbs not included Do not use greater than 60 watt bulb 15 Restore electric power and test your new fixture NOTE Carefully remove the fixture from the carton Check that all parts shown in package parts 1 and parts 2 are included Be carefully not to misplace any of the screws or wire connectors which are needed for installing the fixture Package parts1 10 Support Rod Steel Nisher Whi Description No of pieces ite House Wire Chain 1 ni As fees vee Wire Connection ixture Wire A pre Wire Screw Collar Ring 1 House Ground Wire SS Canopy 1 10 Support Rod 1 Canopy as 2 3 8 Nipple 1 Screw Collar Ring e Hickey 1 B screw Coliar Loop Wire Connector 3 Adjustable Link Screw 1 Steel Washer 3 Chain Hex Nut 6 Adjustable Link Screw Collar Loop 1 Supply wire Adjustable link 2 Ground wire Loop Package parts 2 Description No of pieces Glass shade 9 Arm Glass ne Frame
Download Pdf Manuals
Related Search