Spin Master Air Hogs Zero Gravity Micro User's Manual
Contents
1. FOR INDOOR USE ONLY ADULT SUPERVISION RECOMMENDED TO GET THE MOST OUT OF YOUR ZERO GRAVITY MICRO WALL RACER PLEASE READ THESE INSTRUCTIONS FIRST NOTE USE ON SMOOTH CLEAN SURFACES ONLY Pinok to make sure contents are apa orale Micro Wall Racer Zero FHH Micro 1 Controller Charger all Racer 1 Instruction Sheet INSTALL BATTERIES 1 Switch 2 Switeh Battery lt Compartment controller Voor Six 15 V A Alkaline Rechargeable Batteries 4 Plug cable pn Battery into port S switch on Compartment Ze of vehicle controller ESS Make sure the arrow is on top 6 Green light 7 When charged flashing Vehicle turn controller charge cable is charging 5 charger switch in storage Green light off OFF compartment Vehicle is charged Charging should take between 30 and 90 minutes depending on how much charge is left in car NOTE Do not charge battery immediately after use Let car battery cool for at least 10 minutes If charging is not complete in 90 minutes replace the charger batteries Your Zero Gravity Micro Wall Racer has a pre installed rechargeable battery inside the vehicle body PROBLEMS Before you return to retailer 3 33 call our HOTLINE for assistance 1 800 622 8339 WHILE DRIVING YOUR ZERO GRAVITY MICRO WALL RACER MAKE SURE TO FOLLOW THESE RULES Only drive on smooth clean dry surfaces Make sure walls are clear of obs2. drop or subject to strong impacts Do not allow the battery to get wet Only charge the battery with the specified Air Hogs battery charger Only use the battery in the device specified by Air Hogs Turn the charger off when the toy s battery is charged and always unplug it from the toy Disconnect AC wall chargers from outlets while not in use If the toy has been damaged immediately stop use unplug and safely move the toy away from flammable materials Follow the manufacturer s instructions for charging the toy Do not charge longer than recommended affect the performance Carefully read the instruction manual and use the battery correctly Spin Master Ltd 490 Front Street West Toronto ON MIV 1B6 Canada TM and 2008 Spin Master Ltd Air Hogs is a Contains LiPo batt Spin Master Ine PMB 10053 300 International Drive Suite 100 Williamsville registered trademark of Spin Master Ltd All rights ak Batle 0 ba ahd 14221 USA reserved Conforms to product safety standards pac h attery pa Spin Master Toys Far East Limited Rm 1113 11 F Chinachem Golden Plaza ASTM F963 regulatory requirements Products and must Acker led or GH 77 Mody Rd fsimshatsui E Kowloon HK colors may vary Please retain this information for isposed of properly n spin Master Toys UK Ltd Meadowbank Furlong Road Bourne End Bucks future reference Patent Pending SL8 SAJ United Kingdom MADE IN CHINA Spin Master France 36 rue de Silly 9
3. vehicle turns to the RIGHT press the Left trim button until it drives straight B When finished playing with your Zero Gravity Micro remove vehicle from wall Turn vehicle OFF Turn the controller OFF NOTE The trim setting will reset when the vehicle and controller are turned off PROBLEMS Before you return to retailer please call our HOTLINE for assistance 1 800 622 8339 By pushing the joystick on the controller charger you can make your Wall Racer spin around on the spot RIGHT SPIN LEFT SPIN Push the RIGHT joystick to the right to Push the RIGHT joystick to the left make make the vehicle spin clockwise the vehicle spin counter clockwise TROUBLESHOOTING PROBLEM SOLUTION o O Vehicle will not run 1 Power switch is off Turn on 2 Controller battery is installed with incorrect polarity Check the and markings to make sure the battery is properly aligned 3 Batteries are drained Charge batteries and or install new batteries Vehicle does not climb 1 Over current protection is engaged Turn vehicle off for 30 seconds then restart Vehicle does not drive straight 1 Check trim 2 Make sure surface is clean of dirt dust 3 Make sure surface is neither too rough or too smooth 4 Make sure surface is flat Vehicle slips climbing the walls 1 Clean the tires with a damp rag 2 Fold up the fabric skirts for a better seal prior to use Vehicle falls off the wall 1 Make sure to discharge and then char
4. 2100 Boulogne Billancourt France North American Consumer Information Phone 1 800 622 8339 www spinmaster com Asst 44317 NEN KREVI
5. ge again for 30 to 90 minutes 2 Clean tires and make sure your wall and floor are also clean 3 Check the fabric skirts for damage If they have been pulled loose tape them back on with flexible tape 4 Make sure surface is flat STILL HAVING PROBLEMS Before you return to retailer please call our HOTLINE for assistance 1 800 622 8339 FCC REQUIREMENTS Warning Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocated the receiving antenna Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circu
6. it different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help This Class B digital apparatus complies with Canadian ICES 003 IMPORTANT BATTERY INFORMATION Your Zero Gravity Micro is equipped with a Lithium Polymer battery Do not mix old and new batteries A i Do not mix alkaline standard or rechargeable batteries WARNING Battery installation should be performed by an adult Non rechargeable batteries are not to be recharged Rechargeable batteries are to be removed from the toy before being charged if removable Rechargeable batteries are only to be charged under adult supervision Only batteries of the same or equivalent type as recommended are to be used Batteries are to be inserted with the correct polarity Exhausted batteries are to be removed from the toy The supply terminals are not to be short circuited Different types of batteries or new and used batteries are not to be mixed Exhausted batteries are to be removed as they will adversely Do not leave the toy unattended while charging it Battery charging should be done by adults Charge the toy on a non flammable surface and keep it away from flammable items Do not expose battery to direct sunlight There is a risk of the battery exploding overheating or igniting Do not disassemble modify heat or short circuit the battery Do not place battery in fires or leave in hot places Do not
7. tacles including hanging pictures light switches ete Do not drive on uneven _ The Zero Gravity porous or broken surfaces as vehicle Micro Wall Racer has will not adhere and can fall off working headlights IMPORTANT When the headlights begin to blink the rechargeable battery is running low on power Car should be removed from the wall immediately Otherwise the vehicle may fall off the wall PROBLEMS Before you return to retailer please call our HOTLINE for assistance 1 800 622 8339 DRIVING ON WALLS OR UPSIDE DOWN To drive on walls upside down you must put the vehicle in the WALL mode NOTE Avoid driving overhead when other people are around Do not stand underneath when driving overhead DRIVING ON THE GROUND To drive on the ground you must put the vehicle in the GROUND mode The fan will not turn ON but the headlights will turn on and the vehicle will drive full function on the ground The ground mode saves the battery charge The fabric air skirts can be adjusted outward at a 45 angle to ensure a proper wall suction IMPORTANT The Zero Gravity Micro should only be driven on a smooth clean flat surface Dirt or debris can get inside the fan and cause damage TRIM ADJUSTMENT Place the vehicle in the ground mode and drive forward without touching the right joystick If the vehicle turns to the LEFT press the Right trim button until it drives straight A If the
Download Pdf Manuals
Related Search