SkyLink PT-434 User's Manual
Contents
1. are registered trademarks of their respective corporations PANIC TRANSMITTER USER S INSTRUCTIONS Model PT 434 introduction The Panic Transmitter con veniently fits on any key chain or necklace It allows you to activate Skylink s receivers Secuftiy Control Panel SC 001 SC 002 Emergency Dialer AD 433 Audio Alarm AA 433 Silent Alarm SW 433 from a maximum distance of approximately 100 feet from the receiver This transmitter is water resistant and shock resis tant it allows you to carry this transmitter all the time Smarthome com Inc 800 SMART HOME 949 221 9200 http smarthome com Program the Panic Transmitter to the Security Control Panel SC 001 SC 002 1 Enter the current MPIN Master Personal Identification Number on the SC 001 SC 002 2 Press B 3 Press the number key to identify which zone to add the panic transmitter to Do not program the transmitter to zone 1 2 3 4 The panic transmitter is designed to be programmed in zone 5 for SC 001 and zone 9 for SC 002 Therefore press 5 for SC 001 and press 9 for SC 002 4 The zone light s will flash for eight seconds 5 While the zone light s are flashing press Now both the green and red lights flash for 30 seconds 6 While the zone lights are flashing activate the panic transmitter by pressing the button on the transmitter The red LED light of the sensor will flash You will hear a long beep from the control pan2. cy Dialer and start dialing the preset phone numbers refer to AD 433 AD 002 User s Instruction for details In an emergency you can activate the Skylink re ceivers using the Panic Transmitter Move the slid ing cover and press the panic button for one second This will activate the learned Skylink receiver s l ah Note Make sure you press down on the transmitter for one full second or the sys tem may not respond FCC The Remote Control is WARNING approved by the FCC and Changes or modification3 it complies with Part 15 to this unit not expressly of the FCC Rules Its approved by the party res operation is subject to the _ ponsible of compliance following two conditions could void the user s 1 This device may not authority to operate the cause harmful inter equipment ference 2 This device must accept any interference that may cause undesired Smarthome com Inc 800 SMART HOME 949 221 9200 http smarthome com operation
3. el the zone light will stop flashing and the panic transmitter will now communicate to that zone Battery The Panic Transmitter operates on three 3 volt lithium batteries that are installed at the factory The battery life of these lithium batteries is approximately three years There are two screws on the back of the transmitter that hold the top and bottom case together Recommendation Test your transmitter periodically to ensure that all the batteries are working To replace the Panic Transmitter batteries 1 Undo the two screws on the back of the transmitter The bottom case will then come off 2 Take out all the old batteries using a small screwdriver or a pen 3 Place the new batteries in position The positive end should be facing upward as you place the batteries in the transmitter refer to diagram 4 Close the battery cover and reinsert two screws Smarthome com Inc 800 SMART HOME 949 221 9200 http smarthome com Program the Panic Transmitter to the Emergency Dialer AD 433 AD 002 Press L 5 when in clock mode the display will show L5 I d codE 2 Activate the panic transmitter within 5 seconds by pressing the button on the transmitter The red LED light of the transmitter will be on when the button is _ pressed The display will return to clock mode once _ the panic transmitter has been learned 3 If the button of the panic transmitter is pressed it will trigger the Emergen
Download Pdf Manuals
Related Search