Singer P-1250 Quick Start Guide
Contents
1. SINGER SEWING MACHINE BOBBIN CASE THREADING INSTRUCTIONS Consult Instruction Book for bobbin winding instructions 1 Slide bobbin cover plate toward you Insert wound bobbin 5 Hold top needle thread and turn handwheel toward you into bobbin case with thread spooling off to the left until needle goes to its lowest and then its highest point Raise the presser foot using the presser bar lifter 2 Guide thread to left through notch A and then pull straight 6 Gently pull top thread until lower bobbin thread comes back toward needle so that it passes through notch B up in the form of a loop 3 Leave several inches of thread laying across top of bobbin 7 Use the flat side of a seam ripper or a pin to open up toward the back of the machine bobbin thread loop until end is visible 4 Slide bobbin cover plate back intro position thread tail 8 Pull both thread tails straight back under presser foot should be visible sticking out at top of cover i j P N 357626 002REV 1 SINGER SEWING MACHINE IMPORTANT THREADING INSTRUCTIONS This machine features a special Easy Threading System Even if you have sewn before take the time to learn how to properly thread the machine and you will avoid serious sewing problems in the future 4 Using two hands snap thread into thread guide post A as illustrated PRESSER FOOT LEVER END VIEW 5 Holding thread secure at A pass the thread under guide B 1 Raise pre2. its highest position Lower presser foot should touch spool Thread eye of the needle illustration B IMPORTANT NOTE If thread balls up in the bobbin case or knots up on the underside of the fabric the machine may not be properly threaded DO NOT adjust the thread tension until you have checked for proper threading using the test described in step 6
3. sser foot lever This separates the tension discs in and through the slot guide thread down threading channel the machine that you will be feeding the thread through in to tension system Pull thread firmly up to top of channel step 5 D and then back down again 2 Turn handwheel toward you to raise needle to highest position THREAD 6 Before threading needle test for proper threading as ao RETAINING follows Pull a few inches of thread through theading SLIT channel Lower presser foot to engage tension discs pull a few more inches through There should be a noticeable difference between the thread tension when the presser foot is down and when it is up If the thread pulls through easily when the presser foot is down the machine is not properly threaded and sewing problems will result Re thread the machine and test again SPOOL CAP To pass the thread through the spiral thread guide start from the left making a circular clockwise 3 Remove spool cap Place spool of thread on spool pin movement with your hand twice The thread will with Thread Retaining Slit to right Slide spool cap onto slide inside the center of the spiral illustration A spool pin until it touches spool to prevent thread from Pass the thread through the last thread guide from tangling For large spools of thread larger end of spool right to left and turn hand wheel toward you until cap should touch spool For small spools smaller end needle is in
Download Pdf Manuals
Related Search