Premier Mounts PDS-022 User's Manual
Contents
1. 4 24 PDS 022 Projector Bracket PDS 022 Projector Bracket Installation Instructions y D PREMIER Cad MOUNTS The original holding company M4 x 8mm Phillips Head Screws PDS 022 Bracket Qty 3 Qty 1 s M4 x 8mm Security gt 4 Head Screws Qty 3 Premier Mounts 3130 E Miraloma Ave Anaheim CA 92806 Phone 800 368 9700 Fax 800 832 4888 techsupport mounts com www mounts com VA 1 Using a screwdriver secure the PDS 022 mounting bracket using three 3 1 Invert the projector and place it on a soft and flat surface Remove any foot M4 x 8mm Phillips Head screws Do not over tighten these screws levelers that might possibly prevent the correct installation of the bracket Overtightening the screws may result in damaging the threaded inserts on 2 Locate the three mounting points located on the bottom of the projector the projector 3 Line up the mounting points on the projector with the mounting holes on NOTE Please refer to the PDS Base Box Installation Instructions to attach the PDS 022 mounting bracket the PDS Base Box to the PDS 022 mounting bracket NOTE The projector shown above is for illustration purposes only Installation Instructions Page 1 IN PDS022 RO 4 D LOCK IT Security System 24 a PREMIER P MOUNTS The original holding company LOCK IT Security System Premier Mounts 3130 E Miraloma Ave Anaheim CA 92806 Phone 800 368 9700 Fax 800 832 4888 techsupport moun2. ts com www mounts com NOTE To utilize the LOCK IT Security System all M6 x 12mm Phillips Pan Head screws A must be removed prior to installing the M6 x 12mm Security Screws D Ca 1 Remove all pre installed M6 x 12mm Phillips Pan Head screws a A 6 total ke 9 2 Use the M5 Security Wrench B supplied to install and tighten the oe S se p M6 x 12mm Security Screws D amp Oy A 3 Using the security wrench supplied remove the M6 x 8mm standard i W D set screw and replace it with the M6 x 8mm security set screw C f 4 Insert the nylon washer G 1 4 flat washer H and the M6 x 12mm A Security Screw D into the pivot point I 5 5 Attach bracket to projector using security screws om ONS 6 Once the Phillips Pan Head screws have been replaced with the VS f bE security screws re attach the bracket E to the mount F JER EP 7 ke 7 Insert the four tilt adjustment security screws two per side Od 8 Follow the instructions in the PDS Manual to complete the installation Mounting Bracket Security Screws 1 Using a security wrench supplied secure the PDS 022 mounting bracket using three 3 M4 x 8mm Security Head screws Do not over j tighten these screws Overtightening the screws may result in damaging we l aleet the threaded inserts on the projector LL a Page 2 Installation Instructions
Download Pdf Manuals
Related Search