Philips DVD737 User's Manual
Contents
1. 1 Press SYSTEM MENU on the remote control gt SETUP MENU window appears Press m stop Followed by M4 previous Followed by next The software version will appear on the left bottom corner of the SETUP MENU window uh wn DVD737 Software upgrade procedure NOTE Do not press any button and unplug the mains during upgrade 1 Connect the mains cord to the power plug Press STANDBY ON button on the front panel or POWER button on the remote control to activate the player Press amp OPEN CLOSE to open the disc tray Insert the upgrade CD R disc label side up Press amp OPEN CLOSE to close the disc tray First READING appears on the display followed by UPGRADE This stage of the procedure takes less than 2 minutes ah WwW N gt If the software was successfully downloaded the display will show DONE within a few seconds NOTE If the display shows FAIL please refer to Philips Service Center 6 When the upgrade is completed the tray will open automatically gt Remove the disc immediately Unplug the mains cord from the power plug Reconnect the mains cord to the power plug Press STANDBY ON button on the front panel or POWER on remote control to power up the player gt The player functions as normal2. User Manual for Philips DVD737 upgrade disc Introduction This software can be used to upgrade Philips DVD737 DVD player to the latest status After you have completed the upgrade procedure your DVD player will typically perform better What improvements are made depends on the upgrade software you re using as well as the software that your DVD player contained before the upgrade Tools Required You will need the following items e a personal computer e a CD R RW drive and writing application e ablank CD R or CD RW disc How to download the software to your computer Right mouse button click on the file and click Save Target As to save the file into your PC NOTE Please do not rename the original filename dvd737 rom How to make an upgrade disc Write the downloaded file onto a blank CD R or CD RW disc using the following settings File System CD ROM ISO Level 2 Mode 1 2 XA Character set ISO 9660 Finalised single session Write speed low Finalised the disc The application may do this automatically NOTE Packet writing application for drag amp drop copying cannot be used for creating an upgrade disc Use only a dedicated CD writing application allowing disc at once recording No UDF setting as well Before you upgrade It may be useful to write down the system version information of your DVD player before you start the upgrade procedure in case you need to call service
Download Pdf Manuals
Related Search