Peavey AMD 1220 User's Manual
Contents
1. dual ten segment LED arrays for left and right power on indicator and PFL active indicator Additionally the master section shall contain controls for the AUX A through F sends PFL level control headphone level control headphone jack master output level control and AUX A through D return level controls and pan controls Also AUX A and B return circuits shall contain To AUX A and To AUX B controls to route signals to the AUX A and AUX B sends The patch panel section shall contain transformer balanced female XLR connectors for the outputs of AUX A AUX B left and right There shall be 1 4 phone jacks for AUX A through F outputs AUX A through F auxiliary inputs AUX A through D returns master output and auxiliary input right output and auxiliary input and left output and auxiliary input There shall also be a power switch a switch for the microphone phantom power and connector for an optional gooseneck lamp The unit shall have a metal chassis with high durability polymer end panels soft touch color coded knobs and rubber feet The mixer shall operate on 120 V AC 60 Hz and shall consume 30 watts of power The mixer shall be the Peavey Architectural Acoustics Division model AMD 1220 iginal purchaser of this new Architectural Acoustics product that it is free from defects in material and workmanship If within one 1 year from date of purchase a properly installed product proves to be defective and Peave2. section also contains four AUX returns two stereo and two mono Auxiliary inputs are provided for the left right master and AUX A through F sends An AUX master control is also provided for the AUX A through F outputs A headphone jack with level control will give the operator the left and right outputs when a PFL button in any channel s is activated that signal will be present on the headphone jack PFL volume is controlled by a separate PFL level control The AMD Series also offers dual ten segment LED arrays tor the left and right outputs 48 V phantom power a jack for an optional gooseneck lamp cord wraps for portable operation and soft touch knobs ARCHITECTURAL amp ENGINEERING SPECIFICATIONS The mixing console shall have a 12x 2x1 configuration with six auxiliary sends per input channel and four auxiliary returns in the master section Each channel shall contain a low impedance balanced XLR microphone input with phantom power a high impedance unbalanced 1 4 phone jack line input and a pre equalization send return jack utilizing a TRS 1 4 phone jack Each channel shall have an input gain control high mid sweep and low LIMITED WARRANTY active tone controls six auxiliary sond controls pan control limit LED calibrated 100 mm long throw channel slider PFL switch and pre post switch for AUX C and AUX D sends The master section shall have calibrated 100 mm long throw sliders for left and right
3. L Signal 1 V RMS nominal Ring PFL Switch Signal Grounding Activates PFL HEADPHONE Stereo 8 ohms to 200 ohms nominal Tip Left Ring Right Sleeve Ground 500 mW Total Power Less than 1 Distortion POWER CONSUMPTION 120 V AC 60 Hz 30 watts FEATURES Electronically balanced microphone inputs Transformer balanced outputs Three band EQ with sweepable mid Six AUX sends per channel Limit LED on each channel PFL system 100 mm long throw faders Stereo and mono outputs Four AUX returns 2 mono 2 stereo Ten segment LED arrays for Left and Right 48 V phantom power Socket for optional lamp Headphone jack and level control DESCRIPTION The AMD Series mixers are high performance stereo consoles suitable for applications in churches schools theaters and other venues requiring high quality audio mixing capabilities It is ruggedly constructed with a steel chassis and bottom and high impact polymer end panels The AMD Series features six auxiliary sends per channel two of which are pre fader two post fader and two switchable pre or post Each channel also has a three band equal izer with a sweepable mid range control There is also a pan control to Peavey Electronics Corporation warrants to the assign the channel to the left right or both master controls The left and right submasters are also summed to a mono master output allowing the mixer to be used stereo or mono The master
4. N CHARACTERISTICS 2 dB down mid position LED LEVEL Red 15 dBV 5 62 V RMS MASTER LED METER CALIBRATION 0 0 dBV 1 0 V RMS NOMINAL OUTPUT LEVEL UNBALANCED Master 0 dBV 1 0 V RMS L amp R 0 dBV 1 0 V RMS AUX A F 0 dBV 1 0 V RMS NOMINAL OUTPUT LEVEL BALANCED Master 6 dBV 2 0 V RMS L amp R 6 dBV 2 0 V AMS AUX A amp B 8 dBV 2 0 V RMS NOMINAL HEADROOM Master 19 dB balanced and unbalanced L amp R 19 dB balanced and unbalanced AUX A F 19 dB balanced and unbalanced MAXIMUM OUTPUT LEVEL UNBALANCED Master 19 5 dBV 9 5 V RMS 21 5 cBu L amp R 19 5 dBV 9 5 V RMS 21 5 cBu AUX A F 19 5 JBV 9 5 V RMS 21 5 dBu MAXIMUM OUTPUT LEVEL BALANCED L amp R 19 5 dBV 9 5 V PMS 21 5 dBu AUX A amp B 19 5 dBV 9 5 V RMS 21 5 dBu OUTPUT IMPEDANCE Master 100 ohms L amp R 100 ohms unbalanced 600 ohms balanced AUX A F 100 ohms unbalanced AUX A B 600 ohms balanced OUTPUT NOISE Residual 97 dBV L amp R sliders down Bus 89 dBV All Channel Sliders down Effects Returns down Pans at middle Nominal 84 dBV All channels at 30 dB Gain 150 ohm input EQ flat Pans at middle Sliders at 0 All assigns at L amp R Effects Returns down AUX A D RETURN INPUT IMPEDANCE 33 kilohms AUX A D RETURN GAIN 16 5 dB Max AUXILIARY INPUT GAIN 0 dB Master L R AUX A F FEMLEY ARCHITECTURAL ACOUSTICS PFL AUXILIARY Tip PF
5. SPECIFICATIONS AMD 1220 12 x 2 Mixer SPECIFICATIONS All specifications are typical unless otherwise noted and are referenced to nominal output level 0 dBV unless otherwise noted All measurements are wideband 20 Hz to 20 kHz unless otherwise stated OdBV 1 vot O dBu 778 volt CHANNEL EQUIVALENT INPUT NOISE 133 dBV 150 ohm 25 C 60 dB Gain FREQUENCY RESPONSE 2 dB 20 20 000 Hz all EQ flat DISTORTION Less than 05 0 dB Output 60 dB Gain Typical 003 0 dB Output 30 dB Gain Mic input to L or R outputs EQ flat Sliders at 0 COMMON MODE REJECTION RATIO CMRR Greater than 100 dB typical INPUT IMPEDANCE Mic 2 kilohms Line 10 kilohms Patch 20 kilohms OUTPUT IMPEDANCE Patch Send 100 ohms HIGH EQ 15 dB 10 kHz minimum Center detent flat 2 dB MID EQ 15 dB selected frequency Center detent flat 2 dB MID FREQUENCY 200 Hz to 5 kHz adjustment of mid frequency LOW EQ 15 dB 50 Hz minimum Center detent flat 2 dB MAXIMUM PREAMP GAIN 60 dB minimum MINIMUM PREAMP GAIN 20B MAXIMUM CHANNEL GAIN 70 dB Pan at L or R Slider Max EQ flat MAXIMUM INPUT LEVEL Mic 16 dBV 6 3 V RMS Line 36 dBV 60 V RMS Patch Return 18 dBV 8 V RMS MAXIMUM OUTPUT LEVEL Patch Send 16 dBV 8 V RMS NOMINAL INPUT LEVEL Mic 20 dBV 100 mV 18 dBu Line 0 dBV 1 V RMS Patch Return 0 dBV 1 0 V RMS HEADROOM Nominal 18 dBV Red LED 3 dBV PA
6. he causeot action This limitation of liability will not apply to claims for personel injury or damage to real property or tangible personal property allegedly caused by Peavey s negligence For information on service under this warranty call a Peavey customer service representative at 601 483 5376 o RCHITECTURAL ACOUSTICS Ic sare Features and specifications subject to change without notice A Division of Peavey Electronics Corporation 711 A Street Meridian MS 39301 U S A 601 483 5376 Telex 504115 Fax 486 1278 1994 80302298 Printed in U S A 10 94
7. y is notified Peavey will repair or replace it at no charge Note Batteries and pateh cords not covered Original purchaser means the customer for whom the product is originally installed Damage resulting from improper installation interconnection of a unit or system of another manufacturer accident or unreasonable use neglect or any other cause not arising from defects in material and workmanship is not covered by this warranty The warranty is valid only as to products purchased and installed in the United States and Canada THIS LIMITED WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES EXPRESSED OR IMPLIED INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR USE UNDER NO CIRCUMSTANCES WILL PEAVEY BE LIABLE FOR ANY LOST PROFITS LOST SAVINGS INCIDENTAL DAMAGES OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PRODUCT EVEN IF PEAVEY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE THIS LIMITED WARRANTY IS THE ONLY EXPRESSED WARRANTY ON THIS PRODUCT AND NO OTHER STATEMENT REPRESENTATION WARRANTY OR AGREEMENT BY ANY PERSON SHALL BE VALID OR BINDING UPON PEAVEY Peavey s liability to the original purchaser for damages for any cause whatsoever and regardless of the form of action is limited to the actual damages up to the greater of Five Hundred Dollars 500 or an amount equal to the purchase price of the product that caused the damage or that is the subject of or is directly related to t
Download Pdf Manuals
Related Search