Omega Speaker Systems Metal Liner and Decorative Wood Hood User's Manual
Contents
1. and place 8 x 1 1 4 screws supplied through Figure 5 rear of liner into stud F Installation of Power Units 90026WHI1 Fan Unit see installation instructions enclosed with each Power Unit 90039WHI1 Blower Unit see installation instructions enclosed with each Power Unit 4 X 11 1 4 FILLER BLOCK 3 4 THICK REVEAL 2 PER SCRIBE LINE Figure 6 Source for all parts listed Your local distributor or Omega Industries Inc 1010 Rowe Street Elkhart IN 46516 574 295 5353 or 574 295 5329 fax Form OME 03 12 2002 2002 Omega Industries Inc2. rear of liner C Installation of Omega Industries Inc s decorative Wood Hood 1 Slide decorative hood front into position over T Shaped liner and between adjacent cabinets Install the hood front by ad joining to adjacent cabinets through the front frames using 4 8 x 2 1 2 screws not provided 2002 Omega Industries Inc 181 eo D Installation Galley Rail 28 1 2 or 34 1 2 or 24 1 2 1 An unattached optional Galley Rail assembly may be enclosed with the decorative hood front The Galley Rail should be at tached as shown in Figure 1 NOTE All screw holes should be pre drilled Exercise caution if nailing to avoid damage unite E Installation of Rectangular Metal Liner Figure 4 used for on Uh Me ae CEB site construction of decorative Wood Hood Figure 4 1 Measure down 23 7 8 from top of adjacent cabinets Scribe a level line horizontally across depth of both cabinets 2 Place bottom edge of 3 4 x 4 x 11 1 4 long wood filler block along scribe line Make sure filler block is tight against back wall Figure 5 3 Use four 4 8 x 1 screws supplied and fasten the two wood filler blocks to adjacent cabinets 4 Raise liner so bottom is level with scribed lines Fasten liner to filler block by driving four 4 8 x 1 2 screws supplied through era R 11 ae pre drilled holes 2 per side in liner Figure 6 3 4 THICK REVEAL 2 PER SCRIBE LINE 5 Locate studs
3. IMPORTANT INSTALLATION INSTRUCTIONS FOR OMEGA INDUSTRIES INC s METAL LINER AND DECORATIVE WOOD HOOD Before installation may begin the following components are required e Fan unit part number 90026WHI1 e Blower unit part number 90039WHI1 OPENING 11 1 2 X 22 7 16 Figure 2 DUCT NOT INCL METAL LINER y SCRIBE LINE Figure 3 Form OME 03 12 2002 e Ducting System Metal Liner e Decorative Wood Hood A The Wood Hood is composed of three separate components 1 2 3 NOTE The decorative Hood Front Optional galley rail shipped unattached T shaped Metal Liner Figure 2 T shaped liner shipped with unit as standard Rectangular shaped metal liner available for on site Wood Hood construction Fig ure 4 4 The ventilation system power module and ducting system is not included and must be purchased separately B Installation Metal Liner T Shaped Figure 3 1 Measure up 6 1 8 from the bottom of adjacent cabinets Scribe a level line horizontally across depth of both cabinets Raise Metal Liner so that bottom edge of liner is level with scribed lines Use four 4 8 x 1 2 screws provided to attach liner to adjacent cabinets through pre drilled holes in liner If metal liner is not flush to cabinet sidewalls it may be neces sary to use a filler piece to avoid bowing the liner Locate studs and place two 8 x 1 1 4 supplied through
Download Pdf Manuals
Related Search