Nortel Networks Accelar 8006 User's Manual
Contents
1. 1FA 9592FA 2 Slide the new fan tray into the chassis and 3 When the chassis power is on verify that the tighten the retaining screws green status LED is lit2. Part No 208290 B April 2000 4401 Great America Parkway Santa Clara CA 95054 Installing the Passport 8006 Chassis Fan Tray NORTEL NETWORKS Copyright 2000 Nortel Networks All rights reserved April 2000 Trademarks NORTEL NETWORKS and Passport are trademarks of Nortel Networks All other trademarks and registered trademarks are the property of their respective owners Statement of Conditions In the interest of improving internal design operational function and or reliability Nortel Networks NA Inc reserves the right to make changes to the products described in this document without notice Nortel Networks NA Inc does not assume any liability that may occur due to the use or application of the product s or circuit layout s described herein Federal Communications Commission FCC Statement Note This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy If it is not installed and used in accordance with the instruction manual it may cause harmful interference to radio communications Operation of this equipment in a residential area is likely to cause harmful interference in which case users will be required to take whatever mea
3. sures may be necessary to correct the interference at their own expense EN 55 022 Declaration of Conformance This is to certify that the Nortel Networks Passport 8006 Chassis Fan Tray is shielded against the generation of radio interference in accordance with the application of Council Directive 89 336 EEC Article 4a Conformity is declared by the application of EN 55 022 Class A CISPR 22 Caution This device is a Class A product In a domestic environment this device can cause radio interference in which case the user may be required to take appropriate measures ii About This Guide This guide provides instructions for replacing a fan tray in the Passport 8006 Chassis For more information about the chassis refer to Installing the Passport 8006 Chassis part number 207313 B You can replace a fan tray without turning off power to the chassis To maintain proper cooling of the chassis be sure to install the replacement fan immediately Replacing a Fan Tray Required tool Phillips screwdriver 9590FA 1 Loosen the retaining screws and pull the fan tray out of the chassis until the power connector disconnects from the backplane Wait 10 seconds for the fans to stop turning and then pull the tray out of the chassis Caution Grasp the fan tray at the middle of the front panel and be careful to keep your fingers out of the fan blades 959
Download Pdf Manuals
Related Search