Metra Electronics 99-8714 User's Manual
Contents
1. Refer also to the instructions included with the aftermarket radio 1 Slide the DIN cage into the radio housing and secure by bending the metal locking tabs outward Figure A 2 Slide the aftermarket radio into the Cage until it snaps into place Figure B 3 Snap the pocket into the radio hous ing Figure C Continue to final assembly NOTE Pocket may be installed in top or bottom of radio housing Eee Mens 99 8714 KIT ASSEMBLY STACKED DIN UNITS PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Slide the DIN cages into the radio housing and secure by bending the metal locking tabs outward Figure A 2 Slide the aftermarket units into the until it snaps into place Figure B Continue to final assembly HE Menas 99 8714 FINAL ASSEMBLY FINAL ASSEMBLY A Strip wire ends hack 1 2 Twist ends together C Solder D Tape 1 Locate the factory wiring harness in the dash Metra recommends using the proper mating adapter and making connections as shown Isolate and individ ually tape off the ends of any unused wires to prevent electrical short circuit 2 Re connect the negative battery terminal and test the unit for proper operation 3 Reassemble radio and dash assemblies in reverse order of disassembly FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions in2. INSTALLATION INSTRUCTIONS FOR PART 99 8714 APPLICATIONS SMART FORTWO 2008 993 5714 KIT FEATURES e DIN Radio Provision with Pocket e Stacked DIN Units Provision KIT COMPONENTS A Radio Housing B Pocket TOOLS REQUIRED e Small Flat Blade Screwdriver Panel Removal Tool 1 20 Torx Screwdriver Gwy YQ A 1 800 221 0932 www metraonline com COPYRIGHT 2008 METRA ELECTRONICS CORPORATION LS _ OOOO TABLE OF CONTENTS Dash Disassembly Smart Fortwo 2008 7 Kit Assembly DIN Radio Provision with Pocket 2 Stacked DIN Units Provision 66 cian 4 Note Refer also to the instructions included with the aftermarket radio zh i Mas 99 8714 DASH DISASSEMBLY SMART FORTWO 2008 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit 2 Unclip the Hazard button switch panel Figure A 3 Remove 1 1 20 Torx head screw Figure B 4 Carefully unclip the panel surrounding the radio start at the top of the dash and work your way down Figure C 5 Remove 4 T 20 Torx head screws from around the radio Figure D 6 Disconnect the wire harness and antenna and remove radio Continue to kit assembly O A MHE Mens 99 8714 KIT ASSEMBLY DIN RADIO PROVISION WITH POCKET Note
3. cluded with the head unit Metra recommends making connections as shown below Strip Splice Solder Tape Isolate and individually tape off ends of any unused wires to prevent electrical short circuit METRA EIA WIRING CODE 12V Ignition Acc Red Right Front Gray 12V Batt Memory Yellow Right Front Gray Black A Black Left Front White Power Antenna Blue Left Front White Black Amp Turn On Blue White Right Rear Violet Amp Ground Black White Right Rear Violet Black Illumination Orange Left Rear Green Dimmer Orange White Left Rear Green Black NOTE When a Black wire is not present ground radio to vehicle chassis All colors may not be present on all leads due to manufacturer s specifications 4 NOTES 99 8714 INSTRUCTIONS A 1 800 221 0932 www metraonline com REV 03 27 08 COPYRIGHT 2008 METRA ELECTRONICS CORPORATION INST99 8714
Download Pdf Manuals
Related Search