Metra Electronics 99-7407 User's Manual
Contents
1. IF AN EQUALIZER WILL BE INCLUDED Slide the aftermarket equalizer into the back of the Radio Housing Using the hardware included with the equalizer mount the unit to the kit see Fig A IF AN EQUALIZER WILL NOT BE INCLUDED Snap the Equalizer Dummy Plate into the Radio Housing see Fig B A Strip wire ends back 7 B Twist ends together C Solder D Tape Locate the factory wiring harness in the dash Metra recommends using the proper mating adaptor and making connections as shown Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit Re connect the battery terminal and test the unit for proper operation Mount the head unit kit assembly to the sub dash with 4 screws previously removed in step 1 rev 100103 KIT FEATURES me Shait and DIN unit provisions gt Equalizer provisions KIT COMPONENTS Equalizer Dummy Plate TOOLS REQUIRED p a Phillips screwdriver a Cutting tool Wrench MENA Pa Metra Division of METRACORP 99 7407 INSTALLATION INSTRUCTIONS APPLICATIONS CAR PAGE NISSAN 240SX 1989 94 secesesccccceccssecessscececessesececesseceeees Maxima 1989 94 00n000e00000000000000000000000000000s00000000 Stanza 1987 89 ececesesescccesescecesececsececscesseceseceeees 2 1 800 221 0932 www metraonline com COPYRIGHT 2001 METRA ELECTRONICS CORPORATION NIS2. SAN 240SX 1989 94 Disconnect the negative battery terminal to prevent an accidental short circuit Unclip the gear shifter radio trim bezel and remove the bezel Remove 4 Phillips screws securing the factory head unit and disconnect the wiring Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs C The mounting tabs can be identified by the stamped letter on the back of each tab see Fig A Cut and remove the side portion of Faceplate 1 see Fig B Skip to the Installation Instructions for ALL VEHICLES on Page 2 NISSAN Maxima 1989 94 Disconnect the negative battery terminal to prevent an accidental short circuit Remove 2 Phillips screws above the radio opening Remove the ashtray and 2 screws exposed in the ashtray cavity Unclip the top of the dash trim bezel and remove Remove 4 screws securing the factory head unit and disconnect the wiring Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs B The mounting tabs can be identified by the stamped letter on the back of each tab see Fig A Locate Faceplate 2 see Fig B Skip to the Installation Instructions for ALL VEHICLES on Page 2 NISSAN Stanza 1987 89 Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs A The mounting tabs can be identified by the stamped letter on the back of each tab see Fig A Locate Faceplate 1 see Fig B Skip to the Installation Instructions f
3. or ALL VEHICLES on Page 2 Disconnect the negative battery terminal to prevent an accidental short circuit Remove the ashtray Remove 2 screws from the base of the radio trim bezel Remove 2 screws above the climate controls Unclip the radio trim bezel and remove Remove 4 screws securing the factory head unit and disconnect the wiring 2 SHAFT HEAD UNITS Attach the Faceplate to the Radio Housing Slide the aftermarket head unit into the kit and secure with shaft nuts see Fig A DIN HEAD UNITS Cut and remove the shaft supports from the Faceplate and Radio Housing Attach the Faceplate to the Housing Slide the DIN cage into the kit and secure by bending the metal locking tabs down Slide the aftermarket head unit into the cage until secure see Fig B 2
Download Pdf Manuals
Related Search