Mark Feldstein & Assoc sp1790jk User's Manual
Contents
1. 1 Remove the battery cover at the rear of the remote control unit and insert 2 AAA batteries not included into the battery compartment with correct polarity as indicated 2 Replace the cover and close the battery compartment 3 Remote can be used to Adjust volume Auto tune Put speakers into and out of Standby mode after 5 minutes Speakers will automatically power off NOTE Remote control unit does not POWER ON Speakers Page 4 CONNECTING TO MEDIA DEVICE The rear of the transmitter has one audio cord that can be connected properly to the audio output jack of TV Computer VCR Radio CD MP3 VCD DVD Blu Ray players or to headphone earphone jack with the connector provided Note You may need the included iPhone Adapter to connect your iPhone to the transmitter for audio streaming Simply plug the cable from the transmitter into one end of this Phone Adapter and then plug the other end of the adapter into your iPhone When the transmitter receives an audio signal the blue SIGNAL LED and the red POWER LED will illuminate together If the blue SIGNAL LED does not illuminate ensure that the audio source is turned on If the blue light on the transmitter doesn t light up ensure audio source is turned on and select AUTO TUNE on remote control unit or speakers OPERATION 1 Turn on the audio source TV or audio component to which the transmitter is connected with The blue signal LED on2. please visit www markfeldstein com or call 1 800 755 6504 Mon Fri 8 15 am 5 00 pm Eastern time Page 10
3. SP1790JK 900MHz Wireless Indoor Outdoor Speakers User Manual INTRODUCTION This 900 MHz digital hybrid wireless speaker system uses the latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home You simply connect the system to any audio source such as Radio TV VCR Hi Fi and CD MP3 VCD DVD Blu Ray player Without any complicated wiring and installation this system enables you to enjoy incredible bona fide sound in minutes FEATURES 1 Weatherproof indoor and outdoor speakers 2 Automatic Phase Lock Loop PLL scanning system on speaker receivers 3 Phase Lock Loop PLL transmission system on transmitter 4 900 MHz Digital Hybrid RF technology speaker system 5 Operating distance up to 150 feet 6 Virtually interference free audio quality 7 Standby Mode 8 Wireless remote control unit Independently controls each speaker A Volume up down B Power Off 9 Wall mountable using included mounting gaps on back of speakers 10 2 way speakers IMPORTANT SAFETY INFORMATION l 2 Read and follow all instructions and warnings Do not use liquid or aerosol cleaners Use a damp cloth for cleaning If necessary use a mild soap Page 1 COMPONENT IDENTIFICATION TRANSMITTER pa eee DC IN 12V INPUT O Pe tes On N 7 7 a gane 7 REMOTE CONTROL P owe
4. itch on the channel control of transmitter and then move the speakers to another location You can re adjust the tuning control by changing the channel to 1 or 2 on the transmitter and then pressing the AUTO TUNE button located on each speaker or the remote control for best reception When transmitting receiving over long distances the signal from the system will become weaker This system will transmit through walls floors and other obstacles However range will be maximized by the line of sight placement with no obstacles between the transmitter and the speakers Keep this in mind when placing your equipment throughout your house Page 6 6 To put unit in Standby Mode a To protect the transmitter and save power the transmitter will turn off automatically if it detects that the unit is not being operated or there is weak reception from the signal audio source for 5 minutes In other words if the signal comes back the transmitter will work again automatically b To put the speakers in Standby mode press the power button on the remote control unit The LED light will change from Blue to Green c You can take the speakers out of Standby mode by pressing the power button on the remote control unit If the speakers remain in Standby mode after 5 minutes they will automatically power off ATTENTION The transmitter for this speaker set is designed to work with a variety of devices Our tests have shown the default v
5. mful interference to radio communications However there is no guarantee that the interference will not occur in a particular installation If this equipment does not cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment Page 9 BATTERY NOTICE Do not mix old and new batteries Do not mix alkaline standard carbon zinc or rechargeable nickel cadmium batteries Replace all batteries at same time when they appear to be worn and unit is not operating properly Remove batteries when unit is not used for long periods of time To avoid leakage or explosion do not put batteries in fire WARNING This product may contain chemicals known to the state of California to cause Cancer and birth defects and other reproductive harm Warranty Please return damaged or defective merchandise to the Kohl s store where it was purchased For customer service
6. olume levels of iPods MP3 players and other devices connected to the transmitter through the headphone jack does not have the signal strength required by the transmitter Raising the volume of your device will increase the signal strength to the receiver The blue signal LED will light when the required signal strength from your device is reached We recommend that you keep the volume set on your iPod or MP3 player at a minimum of 3 4 of full volume To Turn Speakers Off 1 Press ON OFF button on individual speakers 2 Put in Standby mode using remote control unit will shut off automatically within 5 minutes 3 Unplug media unit will shut off automatically within 5 minutes WARNING The AC DC power adapters are for indoor use only For all weather use please use C alkaline batteries not included in each speaker This device must be used with the AC DC adapters supplied in the package Page 7 TROUBLE SHOOTING NO SOUND Ensure the AC DC adapter is fully inserted into the wall outlet and the jack located on the transmitter Ensure the speakers are switched on and Blue LED light is visible If the speaker s battery capacity is too low replace with new batteries or connect the AC DC adapters to the speakers Ensure the TV or audio media component is on The connected audio video media equipment is not playing Start playing the equipment If the volume on the speakers is too low adjust the vol
7. r S tan db y Aut O Tune Volume Down Volume Up Page 2 INSTALLATION INSTRUCTIONS TRANSMITTER 1 Insert the antenna tube onto the antenna wire 2 Connect the supplied AC power adapter to an electrical wall outlet 3 Plug the AC power adapter into the DC input jack located on the rear of the transmitter 4 When the AC adapter is plugged in the red POWER LED illuminates If the red POWER LED does not illuminate make sure the adapter is plugged in SPEAKER RECEIVERS 1 Remove Battery cover located on the bottom of each speaker Insert 6 C alkaline batteries not included into the battery compartment with correct polarity as indicated or connect the 9V power adapter included to the DC input jack located inside of the battery compartment Then plug the AC adapter into an electrical wall outlet 3 Replace the Battery cover to close the battery compartment Page 3 4 Press On Off button located on each speaker and turn the speakers ON The POWER LED will light up in Blue To turn the speakers off press the ON OFF button located on the speakers and the POWER LED will turn off 5 To suit the needs of different users these speakers are designed for optional wall mounting There are two holes at the back of each speaker so that they can be hung easily on the wall NOTE Remote control unit does not turn speakers ON Keep speakers within reach REMOTE CONTROL UNIT
8. the transmitter will light up 2 Select the channel 1 or 2 of the transmitter for best performance in your location 3 Turn on the ON OFF button on the speakers the Power button on the remote control unit cannot be used to switch on the speakers Press the AUTO TUNE button to get the best tuning reception in the speakers When the button is pressed frequency tuning starts automatically and it stops when a signal is detected Tuning process can also be activated by pressing the AUTO TUNE button on the remote control unit 4 Volume can be adjusted up by pressing the button or down by pressing the button to the desired listening level or you can press the button or button on the remote control unit to adjust the volume level Page 5 NOTE Press the AUTO TUNE button for the best reception Should you experience any frequency interference move your channel switch from one channel to the other channel there are two channels for selection on the transmitter and then press the AUTO TUNE button again 5 When the batteries are installed your speakers are portable and can be carried freely from room to room and outdoors up to their maximum range of 150 ft Should you encounter any sound disruption signal cuts off or carries distortion press the speaker s AUTO TUNE button to maximize the best reception If you hear interference from the components sw
9. ume to an appropriate level on the speakers or using remote control unit DISTORTED Press the AUTO TUNE button on the speakers until matching the frequency of the transmitter Change the position of the channel selector on the transmitter You must then press the AUTO TUNE on the speakers Battery capacity is too low Replace with the new battery Ensure the volume level of speakers is adjusted properly Ifthe speakers are too far away from the transmitter beyond 150 ft move them closer The input level of the audio is too low Turn up the volume of the audio source equipment Page 8 TECHNICAL SPECIFICATIONS Transmission Mode UHF Carrier Frequency 900 MHZ Digital Hybrid Operation Voltage Transmitter DC 12V 150mA Speakers 6 x C size Alkaline batteries or DC 9V 1A adapter Remote Control Unit 2 X AAA size batteries Frequency Response 40Hz 12KHz Distortion 1 S N Ratio 65dB typical Operation Distance Up to 150 feet Speakers 2 way Output Power 2 x 5 Watts NOTE This equipment has been tested and found to comply with the limits of a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause har
Download Pdf Manuals
Related Search