Linear 3060 User's Manual
Contents
1. 2000 Linear Corporation 214942 B Mini Code INSTALLATION INSTRUCTIONS MINI TRANSMITTER MODEL 3060 Congratulations You have just purchased a Mini Code Digital Transmitter which we believe to be the finest product of its kind on the market With a little care this transmitter should provide you with many years of excellent service Please take a moment to read the following instructions and you will find that setting your new transmitter will be quite an easy matter ACCESSING THE CODE SWITCH AND BATTERY COMPARTMENT The model 3060 Mini Transmitter case is composed of 2 halves which are held together by a small phillips head screw Removing this screw will allow access to both the code setting switch and the battery compartment see diagram 1 BATTERY GV _ a a o O CODE SWITCH TRANSMITTER WITH TOP TRANSMITTER TOP COVER HALF OF CASE REMOVED DIAGRAM 1 SELECTING A CODE Set both transmitter and receiver switches to the code of your choice being sure both are set the same since a different setting of just one switch will prevent operation The digital code is determined by the position of 10 small switches numbered 1 through 10 located in the receiver and transmitter Any combination of on or off positions can be selected by using a pencil or ball point pen Note The switches are in the on position when the switch is depressed toward the number See diagram 2 ON OFF CODE SWITCH2. DIAGRAM 2 Once the codes have been set check operation and reassemble the transmitter case MINI TRANSMITTER INSTALLATION This transmitter is completely self contained including battery and can be operated while held in hand or while mounted in the car It is supplied with hook and loop fabric for easy mounting or it may be added to your key chain using the slot provided TRANSMITTER BATTERY REPLACEMENT Replacement battery 12 volt alkaline lighter battery Eveready A 23 or equivalent The transmitter battery can be checked or changed by removing the phillips head screw located on the back of the case and carefully separating the case halves to expose the circuit board and battery Simply slide out the old battery and slide in the new remembering to observe the battery polarity molded on the case in the bottom of the battery compartment Note that if the red L E D on your transmitter fails to light you most likely have a weak or dead battery and it should be replaced see diagram 1 OPERATIONAL CHECK To check operation move back a reasonable distance about 50 ft and press the transmitter button Operation should be reliable at this distance but environment and
3. location of both the transmitter and receiver will affect the range If the transmitter is stowed well out of sight it may be necessary to remove it from its mounting and hold near the windshield Try different locations and positions If operation is still unsatisfactory the problem may be isolated by 1 Checking the door operator If the door will not open when the wall button is pressed the problem is likely to be the operator If the door will open by pressing the wall button but not when the radio control button is pressed the problem is probably in the radios 2 Replacing the transmitter battery If after perform ing the above operational checks the controls still do not function they should be returned to your dealer for repair or replacement CAUTION Any changes or modifications in intentional or unintentional radiators which are not expressly approved by LINEAR CORPORATION could void the user s authority to operate this equipment This applies to intentional and unintentional radiators certified per part 15 of the F C C rules and regulations This device complies with FCC Part 15 and Industry Canada Rules and Regulations Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation LINEAR CORPORATION 2055 Corte Del Nogal e Carlsbad CA 92009 Copyright
Download Pdf Manuals
Related Search