Lightolier IS:26049 User's Manual
Contents
1. READ AND UNDERSTAND ALL TRACK CONNECTOR FEED IN KITS AND ACCESSORY INSTRUCTION SHEETS BEFORE INSTALLING ANY PROSPEC TRACK ITEM INSTRUCTION SHEET NO This fixture is intended for installation in accordance with the National Electrical Code and local or Federal a code specifications To assure full compliance with codes and regulations check with your local electrical inspector before installation To prevent electric shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference 0197 Page 1 of 1 Installation Instructions for Invisible Coupler For use with ProSpec Track System Only The Mini Coupler is used to join two pieced of track together mechanically and electrically Power cannot be feed into the Mini Coupler Caution Remove Dead End e Turn off power at fuse box before installing the invisible coupler and track e Do not attempt to feed power to the invisible coupler Fig 1 INSTALLING CONNECTOR INTO TRACK SECTION it Remove Dead End Cover if necessary by pulling it out of Track Coupler save Dead End Cover Fig 1 Push Coupler into track until the arrows line up with the track edge Ensure that the contact blades are aligning with the copper wires in the track during assembly Fig 2 amp Fig 3 Tighten the Locking Screw Fig 3 Insert metal spline into the track approximately half the distance of the metal spline length Fig 5 Note orientation of2. spline in Copper Wire channel Contact Blade Insert the assembled track and coupler into the mating track Ensure that the contact blades are aligning with the copper wires in the track Fig 2 Push together until there are no gaps between the track unit sections Fig 4 Check arrows on bottom of coupler If arrows are not in line with the edge of the track realign the coupler until the arrows are in line with the track edges Tighten locking screws Note if there is access from above the track after it is mounted ie track stem installation secure the spline to the mating track using the 2 additional screws Do not use the additional two screws if there is no access The track will have to be removed from the structure to remove the invisible coupler Snap the bottom cover into the track sections Track Unit Invisible Coupler Tighten Screws Secure Screws if accessible after Track is mounted Track Unit Track Unit Track Unit F E j j TOI i E R FALL RIVER MASSACHUSETTS 02720 i MONTREAL QUEBEC CANADA dees
Download Pdf Manuals
Related Search