JVC MV-P618 User's Manual
Contents
1. MV P618 SUPER DIRECTIONAL MICROPHONE nstructions This instruction book is made from 100 recycled paper Thank you for purchasing this SUPER DIRECTIONAL MICROPHONE To get maximum benefit from its use it is suggested that you read this instructions carefully After reading please keep this instructions for future reference COMPATIBLE UNITS MV P618 JVC camera equipped with an XLR 3 pin connector supplying 48 V phantom PRECAUTIONS e MV P618 is a SUPER DIRECTIONAL MICROPHONE exclusively for JVC color video cameras Do not drop or hit the microphone A strong shock may degrade the characteristics of microphone Do not disassemble the microphone The original performance may not be obtained Be careful not to use or leave long time the microphone in a hot or humid place such as direct sunlight near a heater closed automobile in summer E Notes for operation e MV P618 is a high sensitivity microphone designed to give optimum performance This is designed to give best performance at a certain distance from the source Do not locate your microphone too close to the source Otherwise the tone balance is disordered due to the proximity effect Aloud sound near the microphone may cause to distort the sound signal due to the built in mic amp of the camera In addition the sound level may fluctuate due to AGC of VCR Adjust the volume control of the camera to avoid sound signal distortion e When this unit is used on the2. GY DV300 it may pick up the operating noise of the camera To reduce this noise set the menu item of the GY DV300 WIND CUT in the SYSTEM 1 2 to ON In this case however note that low frequencies may not be picked up properly e While recording always monitor the sound level with headphone etc Do not wet the microphone Especially when using in rainy conditions INSTALLATION An example of mounting on the GY DV300 by using KA A33 This unit can be installed on the camera using the optional KA A33 microphone holder Screw Knob Atactimient hole Microphone 1 Loosen the mounting screws on the microphone holder and install the microphone holder on the mount base 7A I 2 Turn the knob on the microphone holder counterclock Pa 1 wise to open the microphone holder Atachiment Mount the microphone on the microphone holder 4 Turn the knob on the microphone holder clockwise to clamp the microphone MIC1 5 Attach the microphone cable to the cable clamp on the microphone holder and connect the cable to the MIC 1 or 2 input connector MIC2 MICROPHONE CHARACTERISTICS Standard Directional Characteristics o o Response 270 90 dB 180 SPECIFICATIONS Reception Second order pressure gradient super directional Type Back electret condenser type Sensitivity 62 dB 0 dB 1 V 0 1Pa at 1 kHz 0 Frequency response 200 Hz to 10 000 Hz Output impedance 50 20 Q Max input SPL 115 dB SPL or
3. more 1 kHz 1 distortion microphone itself S N ratio More than 42 dB Connector 3 pin XLR male Standard Frequency Response 100 200 500 1K 2K 5K 10K 20K Frequency Hz Power supply voltage 48 V Phantom Current consumption 2 6 mA Ambient temperature 5 C to 45 C Dimensions Microphone 160 mm L x 21 mm Dia With windscreen Mass 85g With windscreen Accessory Windscreen e Design and specification subject to change without notice VICTOR COMPANY OF JAPAN LIMITED JVC is a registered trademark owned by VICTOR COMPANY OF JAPAN LTD JVve is a registered trademark in Japan the U S A the U K and many other countries 2002 VICTOR COMPANY OF JAPAN LIMITED a Printed in Japan LWT0056
Download Pdf Manuals
Related Search