Ives 7212V User's Manual
Contents
1. CZ Installation Instructions 7212V 3 4 Offset Jamb Mount Top Pivot 3 32 Allen X wrench Ne Set Right hand Q screw installation D LoS shown left hand opposite Right hand Jamb E Left hand installation leaf installation c p Pivot k pin Prepare and mortise top of door and side jamb to receive pivot set Determine pivot location using dimensions on reverse side The pivots are handed To determine hand of door and proper pivot position see diagrams above Locate drill and tap 1 4 20 mounting holes for metal door or metal frame Locate and drill pilot holes for 14 wood screws for wood door or wood frame Install pivot leafs with 1 4 20 x 3 4 FHMS or 14 FHWS screws provided Loosen set screw in pin leaf with 3 32 Allen wrench provided and remove pivot pin With door in open position about 90 to jamb carefully fit door onto bottom pivot at a slight angle Tip door into vertical position aligning top pivot leafs in door and jamb With pivot leafs aligned insert pivot pin into pivot set Vertically align groove in pivot pin with set screw in pivot leaf Tighten set screw securely with 3 32 Allen wrench To remove door from jamb Use 3 32 Allen wrench to loosen set screw in door pivot leaf Pull pivot pin out of pivots Door can now be removed from opening CAUTION Improper pivot set installation can lead to personal injury or property damage Follow all ins2. tructions carefully For questions contact Technical Support at 1 888 371 7331 LEX Ingersoll Rand 31582 Rev 4 2006 Ingersoll Rand Company Limited Security Technologies It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation Heel edge of door must be beveled 1 8 in 2 as shown below hn 5 8 gt P 3 8 Jamb Leaf 16 mm omi 1 1 8 29 mm 5 16 a 8 mm Face of door NI AN Door Leaf lt a 3 4 19mm 31 582 00 31582 Rev 4
Download Pdf Manuals
Related Search