InFocus SP-CEIL-001 User's Manual
Contents
1. F2 U Step 4 Check all the hardware for proper tightness and security Do not over tighten hardware Continue INSTALLATION INSTRUCTIONS U Step 5 Install the two 2 conical spacers K and two 2 flat washers J two 2 hinge pin screws I loosely on both sides of the base box L Raise the projector with the mounting bracket attached and slip though the SP CEIL OO 1 hinge pin slots openings on the bracket into the base box Install the WARNIN G PROJECTOR MO T two 2 angle locking screws H adjust the angle lock it and then tighten the hinge pin screws I See Figure 3 The ceiling should be capable of supporting a weight of 0 at least five 5 times the weight of 19 Lbs If it cannot the ceiling must be reinforced Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to Failure to do so could result in serious personal injury DESCRIPTION HARDWARE A 4 mm x 20 mm Phillip screws 2ea B 4 mm Quick release sleeves 2ea C Projector Not Supplied D 4 mm x 16 mm Knurl knob lea E SP CEIL 001 F Suitable Hardware Commercially Available G Ceiling Structure See Warning Label H 6 mm x 12 mm Angle locking screw 2ea I 6 mm x 12 mm Hinge pin screw 2ea J Flat washers 2ea K Conical spacer 2ea L PBB 10RL Base box Jam screw lea M Suspension Adapter Adjustable Pins 2ea N SP CE2. IL EXT Adjustable suspesion Adapter Optional For further information or ordering assistance contact us at the phone address number shown on the front of this page F3 Check all hardware for proper tighten and security 27700B S W Parkway Ave Wilsonville Oregon 97070 9215 Phone 1 800 294 6400 Fax www infocus com
3. SP CEIL 001 Projector Mount INSTALLATION INSTRUCTIONS QO Step 1 Invert the projector and place it on a soft and flat surface Locate the three 3 4 mm mounting points found on the bottom of the projector C Secure the two 2 Quick release sleeves B with the two 2 4 mm x 20 mm Phillip Screws A supplied Align the keyhole openings from the mounting bracket E to the sleeves B and secure the bracket with the 4 mm x 16 mm knurl knob D supplied Do not over tighten See Figure 1 F1 U Step 2 install the base box securely to the ceiling structure in accordance with proper commercial standards Use commercially available suitable hardware depending on the installation requirements NOTE If the Optional SP LTMT EXT Adjustable height suspension adapter is a part of the installation securely install the ceiling adapter to the ceiling at this time Refer to its Installation Instructions y SP LTMT EXT ie FIXED CEILING MOUNT o Step 3 Install the two 2 conical spacers K and two 2 flat washers J two 2 hinge pin screws 1 loosely on both sides of the base box L Raise the projector with the mounting bracket attached and slip though the hinge pin slots openings on the bracket into the base box Install the two 2 angle locking screws H adjust the angle lock it and then tighten the hinge pin screws I See Figure 2
Download Pdf Manuals
Related Search