Impex PL-01012RP Owner's Manual
Contents
1. Hex Bolt M8 Nylon Nut Seat Support Backrest Board Seat Pad Computer Sensor Wire Crank Front Roller Cap Rear Stabilizer End Cap 10 QUANTITY o1 O Maintenance and Storage 1 Inspect and tighten all parts each time you use the bike Replace any worn parts immediately 2 The bike can be cleaned using a damp cloth and mild non abrasive detergent Do not use solvents 3 Store the bike INDOOR Excess moisture and water would cause rust on the frame 4 The bike shall be placed at least 24 inches away from the wall or and any other object such as furniture to provide safe access to and passage around the bike 5 To avoid possible injury the help of two or more people are needed when moving the bike around COMPUTER FUNCTION MARK 1 SCAN SCAN 2 SPEED SPEED 3 DIST DISTANCE 4 TIME TIME 5 ODO ODOMETER 6 CAL CALORIE Note This computer is equipped with an auto on off function The computer will turn on automatically if exercise is in motion If exercise stopped for over 4 minutes the computer will turn off automatically FUNCTIONS AND OPERATIONS Function amp Mode Action Scan Press the button until SCAN appears on the screen Monitor will rotate through all functions Time Calorie Soeed Odometer and Distance Each display will hold for 4 seconds Speed Press the button until SPEED appears on screen Monitor will display the current speed in Mile per Hour Distance Pres2. Industry CA 91746 ORDERING REPLACEMENT PARTS Replacement parts can be ordered by calling our Customer Service Department toll free at 1 800 999 8899 during our regular business hours Monday through Friday 9 am until 5 pm Pacific standard time info impex fitness com When ordering replacement parts always give the following information Model Description of Parts Part Number Date of Purchase Popa 13
3. NOTE Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instruction Parts List Warranty Ordering Parts Model PL 01012RP Retain This Manual for Reference 08 29 02 OWNER S MANUAL MP x lt FITNESS PRODUCT S MARCY RECUMBENT BIKE PL 01012RP IMPEX FITNESS PRODUCTS 14777 DON JULIAN RD CITY OF INDUSTRY CA 91746 Tel 800 999 8899 Fax 626 961 9966 info impex fitness com TABLE OF CONTENTS BEFORE YOU BEGIN anane ga ba tect aceite elated ee elie ale fiat cule e tants 1 IMPORTANT SAFETY NOTICES i 554555 nganan eg ga Dep a Dana ga dage yaaa ag an a agan 2 HARDWARE IDENTIFIER sissies idaki aka anaa gae aga a ENG gak a gang a aa a 3 ASSEMBLY INSTRUCTIONS wi acai aranana anana nana e anana anana nana n anana anana anna 4 EXPLODED DIAGRAM ri akas ang Nga a T NELA S EE D ENG a ECEE KEETA Ng ga a ang ka 9 PARTSIISIT aa aaa ia aa aaa aaa aa Naba pana aaa verre sapaa aia Bara la aaa Yaa tech Bada Aia aaa Sa Kg aa 10 GOMPUTER 54 ag aaa naga aa ng aga a naa a aaa aaa a ga a a A A a a a aa a a a a a aga aaa 11 WARRANTY akasa a ah Saab aa aa ka aa an ca a kah GA ENG pa ENG a DANG a ag a Ga D AG reid 13 ORDERING PAR TS d palang aaa pe ma a meet ap a na a eke Dada na Da utente anaes 13 BEFORE YOU BEGIN Thank you for selecting the MARCY Recumbent Bike PL 01012RP by IMPEX FITNESS PRODUCTS For your safety and benefit read this manual carefully be
4. e Running or aerobic shoes are also required when using the machine 7 Use the machine only for its intended use as described in this manual DO NOT use attachments not recommended by the manufacturer 8 Do not place any sharp object around the machine 9 Disabled person should not use the machine without a qualified person or physician in attendance 10 Before using the machine to exercise always do stretching exercises to properly warm up 11 Never operate the machine if the machine is not functioning properly 12 The Maximum Weight Capacity is 300 Ibs 13 Read all warnings posted on the exercise bike 14 Inspect the exercise bike for worn or loose component prior to use Tighten replace any loose or wore components prior to use 15 Care should be taken in mounting or dismounting the exercise bike 16 This exercise bike is only for consumer use only WARNING BEFORE BEGINNING ANY EXERCISE PROGRAM CONSULT YOUR PHYSICIAN THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS WITH PRE EXISTING HEALTH PROBLEMS READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT IMPEX INC ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT SAVE THESE INSTRUCTIONS HARDWARE PLACE WASHER END OF BOLT OR SCREW ON CIRCLE TO CHECK FOR CORRECT SIZE MILLIMETERS M6 M8 M10 INCHES 172 5 8 3 4 IDENTIFIER REPLACEMENT PARTS Thank you f
5. fore using the machine As a manufacturer we are committed to provide you complete customer satisfaction If you have any questions or find there are missing or damaged parts we guarantee you complete satisfaction through direct assistance from our factory To avoid unnecessary delays please call our TOLL FREE customer service number Our Customer Service Agents will provide immediate assistance to you Toll Free Customer Service Number 1 800 999 8899 Mon Fri 9 a m 5 p m PST ww impex fitness com info impex fitness com IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety However certain precautions apply whenever you operate a piece of exercise equipment Be sure to read the entire manual before you assemble or operate your machine In particular note the following safety precautions 1 Keep children and pets away from the machine at all times DO NOT leave children unattended in the same room with the machine 2 Only one person at a time should use the machine 3 If the user experiences dizziness nausea chest pain or any other abnormal symptoms STOP the workout at once CONSULT A PHYSICIAN IMMEDIATELY 4 Position the machine on a clear leveled surface DO NOT use the machine near water or outdoors 5 Keep hands away from all moving parts 6 Always wear appropriate workout clothing when exercising DO NOT wear robes or other clothing that could become caught in the machin
6. he Rear Base 23 Secure it with two M10 x 3 1 8 Carriage Bolts 11 1 Bent Washers 13 and M10 Acorn Nuts 12 E Turn the End Caps on the Rear Base 23 to adjust the stability of the Bases Diagram 1 STEP 2 See Diagram 2 A Connect the Upper Tension Connector 6 from the Computer Post 4 to the Lower Tension Connector 7 from the Main Frame 9 Slide the cable wire from the Upper Tension Connector 6 in between the opening on the wire holder on the Lower Connector 7 Pull the Upper Tension Connector upward and slide the wire through the slot on the bracket then drop it down so the fitting sits firmly on the bracket See How To Connect Tension Connector on next page B Connect the Upper Sensor Wire Connector 3 from the Computer Post to the Lower Sensor Wire Connector 8 from the Main Frame C Hide all the wires inside the post Slide the Computer Post 4 into the Main Frame 9 Secure it with one M8 x 5 8 Allen Bolt 20 and 2 7 8 Washer 22 D Connect the Computer Sensor Wire 31 to the Upper Sensor Wire Connector 8 Hide the wires inside the post Attach the Computer 1 to the Computer Post Secure it with four M5 x 3 8 Philips Screws 2 DIAGRAM 2 HOW TO CONNECT TENSION CONNECTOR 7 Lower Tension STEP 3 See Diagram 3 Slide the Cable wire from the Upper Tension Connector in between the opening on the wire ho
7. lder on the Lower Tension Connector Pull the Upper Tension Connector upward and slide the wire through the slot on the bracket Drop down the Connector so the fitting sits firmly on top of the bracket A Attach the Seat Support 28 to the Seat Post 16 Secure it with five M8 x 5 8 Allen Bolts 20 and 2 5 8 Washers 21 B Attach the Handlebar 25 to the Seat Support 28 Secure it with two M8 x 2 34 Hex Bolts 26 four 5 8 Washers 21 and two M8 Nylon Nuts 27 DIAGRAM 3 N STEP 4 See Diagram 4 A Attach the Backrest Board 29 to the Seat Support 28 Secure it with four M8 x 5 8 Allen Bolts 20 B Place the Seat Pad 30 onto the Seat Support 28 Secure it with two M8 x 5 8 Allen Bolts 20 C Thread the Left amp Right Pedals 14 amp 15 onto the Crank 32 DIAGRAM 4 EXPLODED DIAGRAM y W xX m PARTS LIST KEY NO OONDARWD DESCRIPTION Computer M5 x 3 8 Philips Screw Upper Sensor Wire Connector Computer Post Tension Adjustment Knob Upper Tension Connector Lower Tension Connector Lower Sensor Wire Connector Main Frame Front Stabilizer M10 x 3 1 8 Carriage Bolt M10 Acorn Nut 1 Bent Washer Left Pedal Right Pedal Seat Post Seat Adjustment Bolt Seat Adjustment Knob 7 8 Washer M8 x 5 8 Allen Bolt D 5 8 Washer 7 8 Bent Washer Rear Base Rear Stabilizer Handlebar M8 x 2
8. or purchasing IMPEX Product Although we go to great effort to ensure the quality of our products occasionally errors or omissions occur Should you find either a defective or missing part in this product please contact us for a replacement at the telephone number QUESTION 1 800 999 8899 T NOTE When installing a Aircraft Nut also called Nylon or Lock Nut Please use two adjustable wrenches to tighten down the Nut Hold down the Bolt with one wrench and use the other wrench to turn the Nut clockwise Length T il T oo HEX HEAD BOLT C Rim ll CARRIAGE BOLT ALLEN BOLT AIRCRAFT NUT FLAT WASHER ASSEMBLY INSTRUCTION Tools Required Assembling the Machine Two Adjustable Wrenches and Allen Wrenches NOTE It is strongly recommended two or more people assembling this machine to avoid possible injury STEP 1 See Diagram1 A Attach the Front Stabilizer 10 to the Main Frame 9 Secure it with two M10 x 3 1 8 Carriage Bolts 11 1 Bent Washers 13 and M10 Acorn Nuts 12 B Slide the Seat Post 16 onto the Rear Base 23 Insert the Seat Adjustment Bolt 17 from the bottom through the open slot to hold the desired Seat position and secure with a 7 8 Washer 19 and Seat Adjustment Knob 18 C Attach the Rear Base 23 to the Main Frame 9 Secure it with six M8x 5 8 Allen Bolts 20 and 5 8 Washers 21 D Attach the Rear Stabilizer 24 to t
9. products returned to IMPEX must be prepaid by the customer This warranty does not extend to any product or damage to a product caused by or attributable to freight damage abuse misuse improper or abnormal usage or repairs not provided by an IMPEX authorized service center or for products used for commercial or rental purposes No other warranty beyond that specifically set forth above is authorized by IMPEX IMPEX is not responsible or liable for indirect special or consequential damages arising out of or in connection with the use or performance of the product or other damages with respect to any economic loss loss of property loss of revenues or profits loss of enjoyments or use costs of removal installation or other consequential damages or whatsoever natures Some states do not allow the exclusion or limitation of incidental or consequential damages Accordingly the above limitation may not apply to you The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth herein Some states do not allow limitations on how long an implied warranty lasts Accordingly the above limitation may not apply to you This warranty gives you specific legal right You may also have other rights which vary from state to state Register on line www impex fitness com IMPEX INC 14777 Don Julian City of
10. s the button until DIST appears on screen Monitor will display the distance has traveled Time Press the button until TIME appears on screen Monitor will display the accumulation of riding time Calorie Press the button until CAL appears on screen Monitor will display the calorie consumptions Reset Press and hold the button for more than 2 seconds to reset all data to 0 HOW TO INSTALL BATTERY 1 Pull off the battery cover and place two SIZE AA batteries into the battery compartment on the back of the computer See Diagram below 2 Make sure batteries are correctly positioned and springs are properly contacted with batteries 3 Put the cover back The Battery life is approx 1 year under normal usage 4 Ifthe display is blurred or only partial appeared remove the batteries and wait for 15 seconds then re install the batteries 5 Remove the batteries will erase all computer memories 12 IMPEX INC LIMITED WARRANTY IMPEX Inc IMPEX warrants this product to be free from defects in workmanship and material under normal use and service conditions for a period of two years on the Frame from the date of purchase This warranty extends only to the original purchaser IMPEX s obligation under this Warranty is limited to replacing or repairing at IMPEX s option All returns must be pre authorized by IMPEX Pre authorization may be obtained by calling IMPEX Customer Service Department at 1 800 999 8899 All freights on
Download Pdf Manuals
Related Search