Home Automation OMNI-BUS 125A00-1 User's Manual
Contents
1. by using any Omni Bus Remote Control The remote control used for this does not necessarily need to be one that was previously programmed into the device This allows a lost or stolen remote control to be deleted before reprogramming the new remote control 1 Place the receiving device into the programming mode This is normally done by pressing and holding the button on the receiving device until the receiving device LED starts flashing continuously see receiving device user guide 2 rt ft ae Press and hold any button on the remote control until the remote sounds 3 beeps then 4 beeps and then 5 D UTES S beeps approximately 17 seconds Check for a confirmation signal from the receiving device See receiving device user manual for more information 0 3 Exit the programming mode on the receiving device KEYPAD LOCK FUNCTION The keypad lock function can be used to prevent accidental remote control activation Enabling the Keypad Lock Function Before the keypad lock function can be used it has to be enabled as follows Press and hold button 3 and 4 simultaneously until the remote sounds a burst of beeps after approximately 5 seconds Disabling the Keypad Lock Function Press and hold button 3 and 4 simultaneously until the remote sounds a short beep after approximately 5 seconds Locking Unlocking the Keypad Lock or Unlock the Keypad on the Remote Control b2. HAI Omni Bus 6 Channel Keyfob Remote Control Model 125A00 1 User s Guide SPECIFICATIONS o 6 Channels For use with HAI Omni Bus Output devices Requires an HAI Omni Bus RF Transceiver on an Omni Bus network o Frequency 433 92MHz Range Up to 30m indoors up to 100m outdoors REMOTE CONTROL FUNCTIONS To switch a device ON or OFF Press and release the button on the Remote Control The remote control will toggle between the ON and OFF commands each time the button is pressed To DIM a light when used with an Omni Bus Dimmer unit Enter DIM BRIGHT mode on the Remote control by pressing buttons 1 and 2 simultaneously Press and hold the appropriate button on the Remote Control to dim or brighten the light The Remote Control will exit the DIM BRIGHT mode automatically if no buttons are pressed for 7 seconds A forced exit can be achieved by pressing buttons 1 and 2 simultaneously again OMNIBUS PROGRAMMING See the HAI OMNIBUS Software User Guide for more information on how to program the remote control into an Omni Bus output devices using the OMNIBUS Installation Software MANUAL PROGRAMMING 1 Place the receiving device into the programming mode This is normally done by pressing and holding the button on the receiving device until its LED starts flashing continuously See receiving device user guide for more information Press and hold the DESIRED channel button on the Remote Control until the re
3. mote sounds 3 JLE beeps approx 10 seconds Check Annyi for a confirmation signal from the receiving device See receiving o o ao i device user manual for more information 3 Exit the programming mode on the receiving device REMOTE CONTROL BATTERY REPLACEMENT If the remote control does not respond to any key presses or the LED fails to come on when a key is held in the battery may need replacement The remote control uses one type 23A 12V battery 2010 Home Automation Inc www homeauto com mni Bus DELETING A REMOTE CONTROL A Remote Control channel programmed into an Omni Bus receiving device may be deleted from that device via the OMNIBUS Installation Software or by following the procedure below 1 Place the receiving device into the programming mode This is normally done by pressing and holding the button on the receiving device until the receiving device LED starts flashing continuously See receiving device user guide 2 i ie ao on the remote control until the remote aa sounds 3 beeps followed by another gat set of 4 beeps Check for a confirmation signal from the receiving device See receiving device user manual for more information Press and hold the appropriate button 3 Exit the programming mode on the receiving device DELETE ALL All remote control channels programmed into ANY Omni Bus RECEIVING device can be deleted entirely
4. y pressing buttons 3 and 4 simultaneously The Remote Control will sound a long beep when the Keypad is locked and any key is pressed on the remote control Document 125100 1 Rev1 0 May 2010
Download Pdf Manuals
Related Search