Harbor Freight Tools 8825 User's Manual
Contents
1. Reflector Battery Glass 10 4 Connecting Wire 1 Bulb 18 Battery Lamp Lid 12 Cover 2 Figure E Figure F See Parts Drawing on Page 6 IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE DO NOT OPERATE THE TOOL WARNING BATTERY DISPOSAL The Spotlight is powered by a Battery which will have a long life span When the Battery is no longer functioning the used up Battery should be properly recycled Many states require recycling Contact your local solid waste authority for information on recycling Battery Lifetime Note Always recharge the Spotlight within a 24 hour period after each use Caution Never completely discharge the battery Deep battery discharge will decrease battery life The battery capacity will be reduced if the Spotlight is not used for 3 months Itis recommended that the battery be recharged at least one time every 3 months Note The battery should be charged before the first use MAINTENANCE 1 For better and safer performance keep all parts of this product clean and dry 2 Periodically check to see that all hardware is in place REV 09 03 REV 10 04 01 07 SKU 08825 For technical questions please call 1 800 444 3353 PAGE 5 PARTS LIST PART DESCRIPTION 1 BatteryConnectingWire _ _ _ J 1 2 Rear Cover T 3 Battery _ S d a2 4 Plastic Body Housing _ _ _ 1 Bubber Cover 6 sd 3 Way Slider Switch Cover ____ i f Waterproof st2. 3353 PAGE 6
3. 444 3353 PAGE 3 Note After each use of the spotlight CHARGING INSTRUCTIONS Actual charging of the Spotlight Battery is required before using the Spotlight To recharge the Battery follow the directions below To charge the Battery 3 your Spotlight comes with an AC DC Adapter 19 Lift the Waterproof Stopper 7 on top of Spotlight Insert the round end of the AC DC Adapter 19 into the AC DC Socket 13 Plug the prong end of the AC DC Adapter 19 into an electrical outlet The red charging light will turn on while the battery is being recharged See Figure A B Charging time will take from 10 to approximately 12 hours The red light will shut off automatically when the battery is fully charged After the battery is charged for the required time unplug the AC DC Adapter from the wall socket and the AC DC Socket on the Spotlight Never attempt to turn on the Spotlight while it is being recharged Once recharged with the AC DC Adapter removed the Spotlight is ready to be used A fully charged Spotlight will provide approximately a 20 minute strong beam or 50 minute weaker beam always fully recharge the battery Note This unitis equipped with an automatic shutoff If the Battery s power is running low the unit will automati cally stop operating to protect the battery Charge the battery immediately 6 14 7 13 Figure B Figure C CAR ADAPTER Your Spotlight comes with a Car Adapter 20 21 To operate yo
4. CHICAGO Jaia Power Tools SPOTLIGHT 3 Million Candle Power with 9 Lens a TTAIO8825 OPERATING INSTRUCTIONS Distributed Exclusively by g HARBOR FREIGHT cij TOOLS Gm 3491 Mission Oaks Blvd Camarillo CA 93011 Visit our Web site at http www harborfreight com Copyright 2003 by Harbor Freight Tools All rights reserved No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools For technical questions please call 1 800 444 3353 SPECIFICATIONS ABS Orange with Black Ring 3 Million ON2 Setting 1 Million ON1 Setting 115 Watt Blue Halogen Bulb H 3 12V Two 6V 4Ah Batteries Power Adapter 120 VAC 60 Hz Output Voltage 15 VDC Car Adapter Auto Lighter Type Fused w 5 Ft Long Cord Weight 6 5 Lbs Overall Dimensions 9 W X 11 in Length SAVE THIS MANUAL You will need the manual for the safety warnings and precautions assembly instructions operating and maintenance procedures parts list and diagram Keep your invoice with this manual Write the invoice number on the inside of the front cover Keep the manual and invoice in a safe and dry place for future reference SAFETY WARNINGS AND PRECAUTIONS 1 AVOID WORKING ALONE If an accident happens an assistant can bring help 2 KEEP PRODUCT USAGE AREA CLEAN Keep area free from moisture or oil Cluttered areas invite injuries 3 KEE
5. P CHILDREN AWAY FROM PRODUCT USAGE AREA Allow children to handle this product only with supervision 4 CHECK FOR DAMAGED PARTS Before using this product carefully check that it will operate properly and perform its intended function Check for damaged parts and any other conditions that may affect its operation Replace or repair damaged or worn parts immediately 5 REPLACEMENT PARTS AND ACCESSORIES Use only identical replacement parts 6 ALWAYS BE AWARE OF DANGER OF FIRE and place the Spotlight away from sides of tent or any flammable materials while illuminated 7 DISPOSE OF BATTERY PROPERLY Never put in fire Contact local Hazardous Waste Disposal authorities for proper guidelines 8 NEVER LOOK DIRECTLY INTO THE SPOTLIGHT REV 06 03 09 03 10 04 01 07 SKU 08825 For technical questions please call 1 800 444 3353 PAGE 2 9 AVOID TOUCHING THE LENS as it may become hot during operation 10 DO NOT DISASSEMBLE THE BATTERY or remove any parts from the Battery and surrounding connections 11 DO NOT ALLOW THE SPOTLIGHT TO BE EXPOSED TO FIRE OR HIGH HEAT as this may result in an explosion 12 DISCONNECT POWER Unplug charger when not in use 13 MAINTENANCE For your safety maintenance should be performed regularly by a qualified technician 14 SPOTLIGHT IS NOT COMPLETELY WATERPROOF Warning The warnings cautions and instructions discussed in this instruction manual cannot cover all possible conditions and situ
6. ations that may occur It must be understood by the operator that common sense and caution are factors which cannot be built into this product but must be supplied by the operator Warning Operation of equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker Warning This product contains or when used produces a chemical known to the State of California to cause cancer and birth defects or other reproductive harm California Health amp Safety Code 25249 5 et seq Note Performance of this tool if powered by line voltage may vary depending on varia tions in local line voltage Extension cord usage may also affect tool performance PROPER VOLTAGE WARNINGS Common household current is 110 120 volts As long as the outlet used with the tool is rated from 110 120V there will be no complications using it with household receptacles Plug the tools with Power Adapter into a 110 120V properly grounded outlet protected by a 15 amp dual element time delay fuse or circuit breaker NEVER try to plug a 110 120V tool into a 220 240V circuit or serious complications and possible injury to the operator may occur The plugs have different shapes to prevent this UNPACKING When unpacking your Spotlight check to make sure the following parts are included If any parts are missing or broken please call Harbor Freight Tools at 1 800 444 3353 SKU 08825 For technical questions please call 1 800
7. opper over Adapier Sock 1 ne oOo o 10 Reflector Glass D 11 G assLens _ oO ooo o O T 12 Lamp Lid a 13 ___ Socket Power Adapter i P14 Switch i iESC T 15 Circuit Board 16 Charging Light 17 12Vinliet PR 18 Bulb _ _ _ ____ Y Co oaa I 20 21 Car Adapter _ _ ooo S T o Adjustable Stand front not shown O io o 22b Adjustable Stand back not shown Oo io o PARTS DRAWING NOTE Some parts are listed and shown for illustration purposes only and are not available individu ally as replacement parts PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT IN FACT THE MANUFACTURER AND OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO SKU 08825 For technical questions please call 1 800 444
8. ur Car Adapter remove the Rubber Cover 5 and insert the narrow end of the Car Adapter 21 into the 12 V Inlet 17 underneath Figure A The other end 20 will fit into your cars cigarette lighter socket See Figure C The Spotlight is ready to be used while plugged into the Car Adapter The Car Adapter will not charge the Spotlights battery however While using the Car Adapter take care so that the car s battery does not get discharged OPERATION To assist you with operating your Spotlight please refer to the Operational Figures as well as the Parts List and Assembly Diagram i Push forward on the 3 Way Slider Switch 6 to one of the two ON positions to turn the Spotlight ON Pull the 3 Way Slider Switch all the way back to turn the Spotlight OFF see OFF si jiii Switch right mas 22a Adjust the Stands 22a amp 22b to angle the beam of light to the desired position Figure D Figure D REV 06 03 09 03 08 04 10 04 01 07 SKU 08825 For technical questions please call 1 800 444 3353 PAGE 4 REPLACING BATTERY Remove Rear Cover 2 Remove pin connectors from the old Battery Reconnect Red and Black pins connectors to the proper corresponding connectors on the new battery After connecting properly put the new Battery back in Housing Replace Rear Cover 2 Caution Burns or an explosion could occur if handled improperly See Battery Disposal See Figure E Glass l Lens 11 Batteries 3
Download Pdf Manuals
Related Search