Haier FCD-JTHA40-III(ET) User's Manual
Contents
1. J p J FAQ Haier Household Elec tric Water Heater Only cold water 1 No power to heater Check power and pointer not Contact with service department User s Manual liaht when heat 2 Uncontrollable thermostat g when 1 is excluded ES25H H1 H 1 e water temperature not keep heating EDITA Oa Penk e FCD JTHA40 III ET always light Contact with service department FCD a x Uncontrollable thermostat when 1 is excluded Unconstant flow and Adjust the flux of outlet water or FCD JTHA60 IIIET Insufficient hot E Packing List Electric water heater eS NA eS Expansion Expansion bolt hook pcs Safety valve Drain hose pcs ply set Note This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU To prevent possible harm to the environment or human health from uncontrolled waste disposal recycle it responsibly to promote the sustainable reuse of material resources To return your used device please use the re2. pipe connection to several points like bathroom bathtub washbasin showerhead and kitchen 5 D Ei Installation Installation must be made by installers or designated personnels of our company s after service department The water heater shall be wall mounted oo If there is no power cord or plug and the power is not interrupted the fixing line connected must be equipped with the all pole disconnection device provided by breakaway contact under the overvoltage type Ill condition according to wiring rules Before installation make sure the water heater s rear wires are fit firmly Determine an installation location Make four holes 12mm 65mm deep in the wall with an impact drill according to installating dimension Insert fix expansion hooks and expansion bolts in corresponding wall holes Lift the water heater Insert wall rack onto the hooks and bolts Fit at washers rear wires and nuts in turn onto the bolts see Figure 2 Tighten the nuts and check them firm Install accessories such as safety valve drain hose as shown in Figure 3 Use sealing compound to prevent water leakage To facilitate installation and removal it is suggested a G 1 2 movable nut is fitted at appropriate locations on inlet and outlet pipes respectively Find water supply location Connect inlet pipe outlet pipe and city water pipe respectively to the use point The hot water pipe shall not be too long to reduce the heat losses Please r
3. pressure relief device is to be operated regularly to remove lime deposits and to verify that it is not blocked You also can drain the water heater through the safty valve A pressure release hole Figure 4 4 Heating adjustment can be made flexible all year round adapting to climate changes In long term out of use or maintenance you can close city water pipe valve open mixing valve to hot water range and move up Safety valve handle to drain the tank To avoid injury before next use it is suggested to first open hot water valve before switching on the water heater exhausting gas possibly retained in the pipeline In this case no smoke or fire is permitted near the open valve Carefully check and confirm all parts are in good condition 5 Provided hot water quantity can meet use demand temperature setting shall be possibly low It can minimize heat dissipation high temperature corrosion and sedimentation ensuring a longer service life 6 Regularly ask servicemen to make safety inspection remove sediment on heating elements and check consumption of anode bar Too much consumed anode bar shall be replaced a Cleaning and Maintenance Statement This water heater shall only be repaired and maintained by qualified servicemen Improper maintenance may cause severe injury or damage Before opening or repairing water heater please do disconnect power supply Note Before asking for service please refer to troubleshooting sect
4. E A a ODHE a0 fs 7e fees es froo fioa aso 2an roe on Safe Care patented design together with the unction of monitoring and displaying of live FCDJTHA4O IN a K E E E ILEE E Wall mounting ground wire has become a real safeguard for family safety Drakel 2 Durability FeD THAGO NEN e0 205 7s 725 220 100 305 400 00 Magnesium anode The shell adopts dusting anticorrosion treatment handsome and durable enamel tank with FCD JTHA80 III ET 80 26 5 75 991 440 100 521 400 200 rod eao quay ana ong operatione Remarks The permitted error limit of above parameters is 10 3 Convenience Adjustable heating temperature Adjustable water temperature Electric Circuit Diag ram Adjusting range water inlet temperature 75 C 4 Multiple usage L Brown wire eT BT Enclosed structure capable of supplying water to multiple places like toilet kitchen etc N Blue wire Ta Suitable for family enterprises service trades like beauty care on hot water supply not MT High temperature limiter L drinkable BT Thermostat 5 Ni i HL Heating indicator Nice molding horizontal type wall mounting design saving space EH Heating element The water heater you purchased is the improved model of the series product Please operate E Yellow green wire according to the user s manual CSH10D0810 indd 1 2010 5 7 10 03 04 for Description of the Symbols S Never do that Be sure to act as per in
5. doors with ambient temperature above 0 C The pipes shall be collectively laid Hot water outlet shall not be too far from use points In case farer than 8m hot water pipe shall have a thermal insulation to minimize heat loss The mounting wall shall be firm and reliable to support four times the weight of water heater full of water Non load bearing walls or air brick walls must have corresponding protective measures like additional support wall through screws or back boards Electric water heater shall be located in a place easy for use maintenance and with a floor drainer In case the tank or pipes leak nearby or lower facilities shall not be damaged The installation location shall avoid being above toilet bowl bathtub washbasin or doorframe which will cause a suppressed or unsafe feeling to users Power for water heater shall be in a dry place free of water splash splash proof box is preferred Do not confuse inlet and outlet water pipes Safety valve shall be installed at designated position with no random modification All water pipes should be installed by qualified water pipe installation workers The pipelines should comply with the national standards and regulations on the prohibition of prevention tools todraw water to water source pipelines by way of inverse siphon as well as local building codes The pipelines must be installed by qualified tap water pipe installation personnel The pipelines must comply
6. eserve some space in installation for the future maintenance If there is no plug and the power is not interrupted the fixing line connected must be equipped with the all pole disconnection device provided by breakaway contact under the overvoltage type III condition according to wiring rules oo 0 Safety valve Cold water inlet Cold water outlet valve Mixing valve Hot water Shower head outlet valve Figure 2 Figure 3 for reference in installation only The safety valve should be connected to the cold water inlet pipe Please check carefully if the direction is correct after installation The correct direction of installation is that the arrowhead on the safety valve should point to the water heater Please connect the drain hose to the safety valve Connect one end of the hose to the safety valve vent and the other end to the sewage drain The hose can be cut short or extended as necessary The hose shall be installed as inclined downward see to Figure 4 The water may drip from the discharge pipe of the pressure relied device and that this pipe must be left open to the atmosphere and installed in a continuously downward direction and in a frost free environment Check safety valve once a month as follow move the small handle of safety valve if there s water flowing out safety valve is normal if there s no water flow please contact local after sales service station The
7. ion to resolve easy problems External Cleaning Disconnect power supply before cleaning Gently wipe with wet cloth dipped with a little of mild detergent Do not use gasoline or other solvents Finally dry with dry cloth Keep water heater dry Do not use cleansers containing grinding agent e g toothpaste acids chemical solvents e g alcohol or polishers to clean Internal Cleaning To ensure high working efficiency heating elements and tank liner of water heater shall be cleaned once in three years Take care not to damage protection layer on heating elements and tank liner inner surface According to different local water qualities and use habits magnesium rod shall be periodically replaced If maintenance is needed please contact local service station FAQ Phenomenon No water pressure too low Check and open 1 Hot water access close 2 Temperature not set to desired setting Adjust temperature of water Keep heating Contact with service department when 2 3 are excluded To be continued Only cold water but pointer light when heat 3 Heating time limit and setting temperature not obtained 4 Defective heater CSH10D0810 indd 2 for 2010 5 7 10 03 06
8. pting civil power supply even if the earthing wire is electrified by mistake the Safe Care technology still can block the dangerous electricity and ensure your personal safety But if you find perceptible current please disconnect the power and contact local after service department for maintenance Do not disassemble by yourself Setting Environment Do not set it at place where it is too Do not set at outdoor places cold and may freeze Do not use as floorstanding appliance S Do not install to places without After installation be sure to fill the Q heater completely with water before Please mount it to firm and reliable wall water drain hose connect the drain hose to the inlet of the sewer to avoid polluting by splashing O In case connecting water heater with sewer The original pipeline of the water heater is an organic part of Safe Care Do not remove it by yourself Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred therefrom 3 B Attentions in Installation During installation adequate space must be reserved for future maintenance and repair If the water heater is installed within decoration boards the right board shall be removable to facilitate removing the plastic cover during maintenance City water inlet pressure shall not be less than 0 05MPa Maximum pressure can not exceed 0 75MPa Electric water heater shall be installed in
9. re1 jno less than 0 05MPal professional repair until the mark goes off 230V 50Hz 2000W 0 80MPa IPX4 See to Figure1 no less than 0 05MPa Pre safe Expert will become the electric safeguard for your family 220 240V 50 60Hz 1650W 0 80MPa IPX4 See to Figurel jno less than 0 05MPa Before Usage All the rated power mentioned above are available for this model For more details please refer to the nameplate Dear users Thanks for choosing Haier water heater product Dimensions Haier products have good quality and excellent performance To facilitate you to use the Ure product please read the manual and operate accordingly Please retain it for future reference Front view Cutaway view Bottom view at The international star service of Haier Group will always accompany you No matter what kind lt of problems you meet in usage please contact with the local after sales service agent We are at your service all the time Thanks again for choosing Haier Product The water heater you purchased may not full comply with the manual due to the improvement of product We apologize for the inconvenience occurred therefrom Ez Features Volume Rated lalalala A Hot water outlet Model veo temperature 1 Safety fo mm mm mm mm mm mm B Cold water inlet High quality heat proof stainless steel electric heating element overtemperature protection ES25H H1 H C Heating element sper soar
10. structions E Safety Precautions Check if the ammeter and the diameter of the wires are in accordance with the rated current of the water heater If necessary please have it checked by experienced electrician The product is only available for alternating current Be sure to use independent power and earth it reliably Set the power of the water heater at dry position away from water spraying In opening and closing the water valve do not point the shower head to human body Otherwise it may hurt by the spraying hot water switching on the power in the first usage Children must take bath under the supervision of adult In case the power cord of the water heater is damaged be sure to have it replaced by after service technicians with special cord offered by the manufacturer In winter of cold area if the heater is idle for a long period please pull the handle of safety valve to discharge the water Otherwise it may freeze inside the water heater and cause damages This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance The product adopts the patent Safe Care technology of our company As long as ado
11. turn and collection systems or contact the retailer where the product was purchased They can take this product for environmental safe recycling O0 Please read this manual before usage 0040500304 O0 Retain it for future reference Ha lIe 2010 07 26 O0 See the physical product for the appearance colour or pattern for oO Pre safe Expert ggj Parameters This mark is the designation for Pre safe Expert of Haier Water Heater Rated voltage Company which indicates use of the company s patented technology Frequency _ power pressure __grade_ Weight Volume inside the product It ensures you a safe bath while monitoring 220V 50Hz 500W 0 80MPa __IPX4 __ See to Figure jno less than 0 05MPa whether your house ground wire is live or not all the time If this 220V 50Hz 800W 0 80MPa IPX4 See to Figurel no less than 0 05MPal s s p 4 mark is lighted on it indicates your house ground wire has come live 220V 50Hz 1200W 0 80MPa IPX4 See to Figure1 no less than 0 05MPa PTO 0 poor grounding and live In this case please immediately stop use 220V 50Hz 1500W 0 80MPa PX4 See to Figure no less than O 0sMPal 7 and disconnect the power and remember not to touch any electric Mark of appliance shell in your house At the same time immediately contact 230V S0HZ 1650W 0 80MPal__IPX4 see to Figure jno less than 0 05MPa Haier Safe Water Heaters after sales service and your property management company for 230V 60HZ 1650W 0 80MPaj IPX4 See to Figu
12. with applicable national standard that specifies preventing of non drinking water in the appliances from being siphoned back to the water source as well as local construction regulations F Operation Instructions For the first use after installation due to the dryness of the tank first the city water inlet valve and mixing valve must be opened Close the mixing valve when water flows out continuously from the showerhead or other outlets the tank is full Check connections are free of water leakage and connect power Turn the knob to set your desired water heating temperature which can be stepless changed between cold water inlet temperature and 75 C In heating mode heating lamp is lighted on Normally the knob shall be positioned at highest temperature This machine has a thermostat function which automatically switches off the water heater when temperature reaches the setting value and switch on again when water temperature decreases to certain value City water pressure gt 0 80MPa will cause much water fiowing out from safety valve presuure relief vent This is due to too high water pressure Please ask after sales service for correction a Attentions in Operation 1 To avoid causing machine troubles do not connect power before tank is full of water 2 Adjust a suitable temperature before use for water temperature above 50 C may burn your skin 3 This product is closed water heater which can supply hot water through
Download Pdf Manuals
Related Search