Graco SoundSleep Nursery Monitor User's Manual
Contents
1. Battery dead or weak replace or use AC adapter Channel settings do not match set both units to same channel AC adapter not properly connected check the connections Nursery Unit covered or blocked remove the obstruction WEAK SOUND Parent s Unit too far from Nursery Unit move closer Large objects blocking the signal try repositioning Nursery Unit Check that antennas are vertical and are not touched by other objects Volume setting too low turn it up STATIC Interference from other electrical equipment eliminate cause of static TVs mixers computers fans fluorescent lights light dimmers etc Parent s Unit too far from Nursery Unit move them closer Channel settings do not match set both units to same channel Try other channel on both Parent s Unit and Nursery unit SHRILL NOISE FEEDBACK Nursery Unit and Parent s Unit too close together move them farther apart Volume set too high lower the volume If you cannot solve the problem please contact our Customer Service Department at 1 800 345 4109 Do not attempt to modify the unit Any modifications to the transmitter and or receiver can void the operator s authority to operate the equipment 15 162. SoundSleep Nursery Monitor b GRACO OWNER S MANUAL Model No M Channels C Serial No S Dear Customer Please fill in the model and serial numbers above from the label inside the battery compartment of your new Nursery Monitor Both Parent s Unit and Nursery Unit MUST be set to the same channel for the system to operate 1998 Graco 901 5 98 Please read this Owner s Manual completely BEFORE first use of your monitor Pay special attention to the warn ings Keep these instructions for future reference Congratulations on your purchase of a Graco Nursery Monitor Graco is the recognized leader in the design and manufacture of quality baby products We believe your new Graco Nursery Monitor is a wise choice Before using your Nursery Monitor please take a few minutes to read this Owner s Manual The short time you spend reading these instructions will help you use your Nursery Monitor properly Please save your Owner s Manual for future use Customer Satisfaction Our goal is to make every product the best it can be We are also committed to supporting our products after purchase If you would like to speak with Graco about your product please contact our Customer Service Department at 1 800 345 4109 Our knowledgeable staff will be ready to answer any questions you may have concerning parts use or maintenance When you call please have the model and seri
3. al numbers ready so your call may be processed quickly and efficiently 2 Failure to follow these warnings and the assembly instructions could result in serious injury or death This device is designed only to monitor the sounds of your child It will not alert you to your child s silent activities This product is not designed or intended for use as a medical monitor Always be sure that both the transmitter and receiver are working properly and are within range of each other STRANGULATION HAZARD Keep the adapter cords out of the reach of children Do not use with extension cords DO NOT place the Nursery Unit or its cord within your child s reach Do not put the Nursery Unit inside a crib or playard DO NOT OPEN THE TRANSMIT TER RECEIVER OR ADAPTER NO USER SERVICEABLE PARTS INSIDE RISK OF ELECTRIC SHOCK FIRE OR DEATH DO NOT immerse any part of the Nursery Monitor in water Clean only with a dry cloth DO NOT place unit near water and moisture Do not use the Nursery Unit outdoors Do not use the monitor near possibly wet areas such as a bathtub shower wash basin sink laundry tub swimming pool wet basement etc Keep Nursery Monitor away from heat sources such as fireplaces radiators stoves and TVs or other appliances Heat can damage the case or electrical parts Use ONLY with 110 120 volt AC electrical outlets Protect the AC adapter cords Place th
4. e these adapters with other equipment under any circumstances If units do not work check that AC adapters are plugged into working outlets When electricity is off from a power failure etc the transmitter will NOT work since it only operates on AC current 12 System Setup SETTING UP THE MONITOR 1 Check that both Nursery Unit and Parent s Unit are set to the same channel 2 Place the Nursery Unit within 10 feet 2 3 meters of your baby Plug an AC adapter into the jack on the side of the Nursery Unit Plug it into a working 120 volt AC outlet 3 Aim the Nursery Unit toward your baby Check that there are no walls or large objects that could block sound transmission AWARNING Do not place the Nursery Unit or AC adapter cord within your child s reach DO NOT place Nursery Unit inside a crib or play yard 4 Turn on the Nursery Unit using the ON OFF switch on the left side The red power light should come on 5 Install a nine volt battery into the Parent s Unit or plug it into a working 120 volt AC outlet using the other AC adapter 6 Turn on the Parent s Unit using the volume control dial on the right side The red power light should come on 901 5 98 13 TESTING THE UNITS It is VERY IMPORTANT to test the system when first set up and at regular times thereafter Test the units any time they may have been damaged or have not been used for a long time 1 If two adults ar
5. e present have one take the Parent s Unit to different locations trying various volume settings while the other speaks into the Nursery Unit 2 If only one adult is available place a ticking clock radio or other sound producing device near the Nursery Unit to test it 3 When testing keep the level of your child s sounds in mind and adjust the volume accordingly 4 If there is sound interference switch both the Nursery Unit and the Parent s Unit to the other channel setting NOTE As with all radio frequency devices transmission range and reception may vary Your Nursery Monitor uses public airwaves so it is possible for conversations near the Nursery Unit to be broadcast to other nursery monitors radios cordless phones or scanners outside your home For your privacy always turn off the Nursery Unit when not in use This monitor operates on one or more of the following frequencies 49 830 Mhz 49 845 Mhz 49 860 Mhz 49 875 Mhz 49 890 Mhz Maximum signal strength is 10 millivolts meter at 3 meters 14 Solving Problems Most problems have a simple solution First check that e Power is turned ON for both units e Both units are plugged in or battery is fresh in Parent s Unit e Electrical outlet works e Units are set to same channel e Volume is turned up on Parent s Unit e Parent s Unit is in range of the Nursery Unit If necessary try the following ideas NO SOUND
6. em so they are not walked on or pinched by furniture or other items DO NOT use the monitor if The adapter cords or plugs have been damaged The unit has been exposed to liquids Unit has been dropped or is damaged inside Allow for proper ventilation when units are in use Do not cover the nursery or parent s unit with any object such as a blanket Do not place it in a drawer or in any location which would muffle the sound or interfere with the normal flow of air FCC ID M6Y002020049R M6Y002020049T 4 Product Features FRONT VIEW Antenna Antenna Power Light Channel Channel Selector Selector Power Light a i On Off ae Volume i Os Control o oo o o o o o o o o a 6 Nursery Unit Transmitter Parent s Unit Receiver Both the Parent s Unit and the Nursery Unit MUST be set to the same channel If receiver detects sounds from another nursery monitor or cordless phone set both units to the other channel If problem persists contact Graco 901 5 98 5 6 REAR VIEW Hand Grip MPRA e ip AC Adapter N AC Adapters 2 included Battery Compartment AC Adapter Jack Side Slot Installing A Battery Using AC Adapters Battery changing should only be done by an adult The Parent s Unit can be operated on battery power 1 Push a key screwdriver or other object at an angle into the side slot under
7. the AC adapter jack as shown and lift up to open the battery compartment 2 Snap a nine volt battery into proper terminals An alkaline battery is recommended Place battery into compartment 3 Snap battery compartment cover closed BATTERY USE TIPS Remove battery from Parent s Unit if it will not be used for a long time Remove a dead battery promptly A dead battery left in unit may leak damaging your unit Do not attempt to recharge a non rechargeable battery A rechargeable battery CANNOT be recharged by plugging AC adapter into the Parent s Unit Remove the battery from unit to recharge it 901 5 98 9 Push in at angle and lift X Charging of a rechargeable battery should only be done by an adult Battery power will be conserved when Parent s Unit is powered through AC adapter It is not necessary to remove battery when using AC adapter Change battery if Signal reception becomes poor Static noise develops also check for appliance interference The Parent s Unit can use either a battery or standard 120 volt AC household current The Nursery Unit uses standard 120 volt AC household current only The included AC adapters must be used for this purpose To use AC adapters plug the connec tor on the cord into the AC adapter jack on the side of the unit Then plug adapter into a standard wall outlet 11 Use ONLY the Graco adapters included with the unit Do not us
Download Pdf Manuals
Related Search