Foundations 100-SSC-R User's Manual
Contents
1. Foundations DIAPER CHANGING STATIONS Model 100 SSC R Clad Stainless Steel Changing Station Installation Instructions Recessed Mount Thank you for purchasing a quality Foundations product Our goal is 100 consumer satisfaction If for any reason you are not satisfied or if you have questions regardin your product or installation please contact our customer service team at 1 877 716 2757 Please DO NOT contact your distributor or reseller as we are better prepared to assist you A WARNING Failure to follow these warnings and the installation instructions could result in serious injury or death Read all instructions before installing diaper changing station Keep these instructions DO NOT discard 1258R D INSTALLATION INSTRUCTIONS ADULT INSTALLATION REQUIRED A TOOLS REQUIRED To 6 o Level A Measuring tape B c D Power drill with 3 16 masonry bit C SSSss E aes Power screwdriver with bull nose phillips bit D i Truss head spanner bit E E aso e READ ALL INSTRUCTIONS BEFORE ASSEMBLY OF DIAPER CHANGING STATION e Unpack carton and identify all parts A WARNING e This changer has six 6 recess mounting holes e The diaper changing station is no stronger than the anchors or walls to which they are attached and therefore MUST be firmly secured in order to support the weight they are intended to support Contact an architect or building contractor if any questions2. PARTS LIST Parts Description Quantity Hardware for recessed installation 3 x 1 4 Wood Screws 6 Door Wall Plate 1 Door wall plate to be mounted on outside of restroom door A D A Compliance Maximum Protruding Objects Forward Reach 2 Parallel Approach 27 4 Operation liant when properly installed 21 3 8 542 mm 333 mm 34 3 4 883 mm Door INSTALLATION Recommended Blocking elan ae J 4 mm Wood double stud blocking is necessary Contact an architect and IN WwW building official to make sure the blocking is adequate and complies with building codes Fig a 35 5 8 905 mm Rough in i For A D A compliance top of lower double stud should be 30 76 cm from the floor 1 Slide changer into blocking area and mark mounting hole location on blocking studs 19 5 8 Double Stud Double Stud HINT This may require 2 additional people to help hold changer 18 Rouge in position while you are marking the locations Gy tan 2 Use a power drill with a 3 16 bit and drill six 6 pilot holes in the blocking studs raana Po es Compliance 3 Shim changer for a snug fit ee A F F H NOTE If lower holes are inaccessible remove plastic unit from steel Figa back by removing the 4 Truss Head Spanner Screws fig c Once Recess steel back is attached to blocking reconnect plastic wall to steel Moun
3. ting Recess back using the same spanner screws Holes Mounting Holes 4 Align holes in changer with drilled holes and secure using the wood screws Wood screws have been provided and are for wood only Fig b Recess NOTE It is installers responsibility to provide correct fastereners won a for other substrates 5 Ensure all six 6 screws are tight OPERATION Truss Head Spanner Screws Rotate base downward Place infant on top of the changing surface Use restraint system as described below After child has been changed remove restraint system S S and rotate base back up against the wall 0 a 0 ol low o USE OF RESTRAINT SYSTEM D Zz Place child so restraint strap is located at abdomen Rotate top of buckle upward and insert strap in buckle Pull strap through buckle until snug against infant Rotate top of buckle downward to lock the strap into place Slide red locking tab over top of buckle Fig d Reverse steps to loosen strap U Fig c MAINTENANCE AND CLEANING Check all hardware and components monthly or as required to ensure hardware is tight and there Top Of Locking are no missing or damaged components Take unit out of service if any component is missing or p Tab damaged and contact customer service to order replacement parts Do not substitute parts Buckle For replacement parts contact customer service at 1 877 716 2757 Clean b
4. y using a damp cloth with mild soap or mild multi purpose cleaner Do not use any strong chemical cleaners or cleaning agents that may be hazardous to children Fig d A WARNING Child should never be left unattended Avoid serious injury from falling or sliding out Always use restraint system Adding excessive weight such as parcels packages or accessories to the unit or to the bag hooks that exceed the total weight limit of 50 pounds 22 7 kg may cause the unit to be unstable or may cause a hazardous unstable condition to exist
Download Pdf Manuals
Related Search