De'Longhi DRAGON HM3 User's Manual
Contents
1. and will give many years of trouble free service W ipe radiator with soft damp cloth do not use detergents or abrasives If necessary use a vacuum cleaner to remove any built up dirt Important notes Do not use your radiator close to bath wash basin shower and swimming pool Do not use your radiator to dry laundry Never place the power cable on top of the radiator while it is hot Only use the radiator in an upright position The heater must be positioned at least 50 cm from furniture or other objects If the power cable has been damaged it must be replaced by the manufacturer or the technical service centre or by a qualified per son so as to avoid all risks In order to eliminate the radiator s new smell set it to maximum power for at least 8 hours when used for the first time D uring this Operation the room in which the radiator is located must be venti lated Itis perfectly normal for the radiator to make creacking sounds when used for the first time or in the case of unfrequent use The radiator must not be located immediately below a fixed socket outlet The body of this radiator is filled with a precise quantity of special oil so that repairs requiring the opening of the oil body must only be made by the service agent Any oil leakage must be reported to the service agent Do not use this appliance in rooms having a floor area of less than 4m as this can lead to overheating2. plug having a fuse of 13 amp capacity Should this plug not fit the socket out lets in your home it should be cut off and replaced with a suitable plug following the procedure outlined below Note Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might find it and plug it into a supply socket with the obvious consequent danger N B W e recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use important the wires in the mains lead fitted to this appliance are coloured in accordance with the following code GREEN ANDYELLOW EARTH BLUE NEUTRAL BROW N LIVE As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red W hen wiring the plug ensure that all strands of wire are securely retained in each terminal Do not forget to tighten the mains lead clamp on the plug If your electricity
3. supply point has only two pin socket out lets or if you are in doubt consult a qualified electrician Should the mains lead ever require replacement it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size After replacement of a fuse in the plug the fuse cover must be refitted If the fuse cover is lost the plug must not be used until a replacement cover is obtained The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug Always state this colour when ordering a replacement fuse cover Only 13amp replacement fuses which are asta approved to B S 1362 should be fitted This appliance conforms to the Norms EN 55014 regarding the sup pression of radio interference GB 3 06 2004 11 27 Pagina 6 F 5710008300 05 04
4. GB 3 06 2004 11 27 Pagina 1 _ DeLonghi instructions DRAGON HM3 Please retain these instructions for future reference Living innovation a GB 3 06 2004 11 27 Dragon HM3 Living innovation Pagina 2 Thank you for choosing this De Longhi radiator To get the very best out of your new radiator it is advisable to read these instructions before using it This will ensure that you gain optimum results and use the appliance safely General instructions Take the radiator out of its packing box and remove any polystyre ne pieces or any other packaging material that might be lodged inside it Make sure that the radiator has not been damaged during transit and that the mains cable is in working order Do not operate the radia tor if damaged Easy wheel system Turn the radiator upside down on a rugor a soft surface in order to prevent damaging the paint finish Fully unfold the castors by turning them outwards Fig 1 Turn the radiator back to its upright position Electrical connection Before plugging the radiator into the mains check that your supply voltage is the same as that shown on the rating plate of the radiator If using more than one appliance at a time it is important to ensure that the ring main is adequate to cope with the power requirements It is important to ensure that the socket is adequately earthed This radiator complies with EEC Directive 89 336 relatin
5. If the appliance is scrapped provisions on the disposal of oil must be respected The use of an extension lead is not recommended as overheating of the extension lead may occur during the operation of the radiator As with any electrical appliance whilst the instructions aim to cover as many eventualities as possible caution and common sense should be applied when operating your appliance particularly in the vicinity of young children The appliance is fitted with a safety device which will switch off it in case of accidental overheating To reset disconnect the plug from the power for 30 minutes remove the cause of overheating then plug the appliance in again ATTENTION in order to avoid any danger caused by an accidental resetting of the safety system this appliance must not be powered through an external timer Oo IMPORTANT Do not cover the radiator during ope ration as this could lead to dangerous overheating GB 3 06 2004 11 27 Warning this appliance must be earthed Green and Yellow to Earth Neutral Cord Clamp Dragon HM3 Living innovation Pagina 5 Electrical requirements Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home if you are in any doubt about your supply contact your local electricity company The flexible mains lead is supplied connected to a B S 1363 fused
6. g to electromagnetic compatibility How to use it Switching on Plug the radiator in position the thermostat slider to maximum and turn the radiator on as follows using the power selector Turn the power selector to position 1 to select minimum output the light on the left will come on Turn the power selector to position 2 to select medium output the light on the right will come on Turn the power selector to position 3 to select maximum output both lights will come on Adjusting the thermostat Leave the thermostat at its highest setting until the room has reached the required temperature T hen slowly turn the thermo stat slider back until you hear a click T he temperature selected in this way will then be regulated automatically and kept constant by the thermostat GB 3 06 2004 11 27 lil MD S Y Y Y S AA S PD Fig2 operating time Dragon HM3 Living innovation Pagina 3 Frost protection function W ith the thermostat slider in the minimum position and a power selected the unit maintains the room at a temperature of about 5 C preventing freezing with minimum energy consumption Models with 24 hour timer Using the timer If you wish to use the timer position the switch in the middle position Fig 4 Setting the correct time Check the time on your watch If for example it is 4 00 pm 16 00 turn the dial in a clockwise direction until the numbe
7. r 16 is lined up with the triangular pointer fig 2 N B N ever turn the dial in an anti clockwise direction The timer is in effect an electric clock and works only if the plug is connected to the power supply W henever the plug is disconnected or there is a power failure the clock must be re set To program the timer 1 Set the operating times by pushing out with your thumbnail to the outer rim the notches on the dial corresponding to the period required fig 3 each notch represents 15 mins 2 Make sure that the timer indicates the correct time see instruc tions on setting the correct time 3 Turn the radiatior on and set it to the heat setting and tempera ture level on the thermostat as required Once programmed in this way the appliance will repeat the pre established program every day if the selector is in the position Timer override If you wish to override the timer settings push the timer switch to position 1 fig 4 manual timer override To return to timed opera tion push the switch back to the middle position fig 4 _ 0 I Manual timer override fig4 t amp Timer operation 90 Heater off NOTE if the timer switch is at the O position fig 4 the heater is off and will not operate GB 3 06 2004 11 27 Dragon HM3 Living innovation Pagina 4 Cleaning and maintenance Your oil filled raditor is absolutely free from maintenance fully relia ble
Download Pdf Manuals
Related Search