De'Longhi DCH7093ER Instruction Manual
Contents
1. INTRODUCTION Thank you for choosing a De Longhi product Please take a few minutes to read these instructions This will avoid all risks and damage to the appliance IMPORTANT SAFEGUARDS _ __ Do not use the appliance near showers bathtubs sinks swimming pools etc Always use the appliance in an upright position Do not use the appliance to dry laundry Do not obstruct the air intake and outlet grilles danger of overhea ting The appliance is not intended for use by persons inclu ding children with reduced physical sensory or men tal capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance The heater must be positioned at least 50 cm from furni ture or other objects Do not use the appliance near walls furniture curtains etc The use of extension leads is not recommended However if they cannot be avoided follow the instruc tions accompanying the extension lead and never exce ed the power limit marked on the extension If the power cable is damaged it must be replaced by the manufacturer an authorised service centre or a qua lified electrician in order to eliminate all risk The appliance must not be placed immediately under a fixed power socket Do not use the appliance in rooms with a floor area2. a a il 5 1 Fan 8 In this mode only the fan operates and the appliance does not heat the room Description Use ry 5 2 Freeze prevention In this mode the appliance keeps the room at a temperature of 7 C to avoid freezing 5 3 Heating 1 2 and Heating 3 In this mode the desired temperature can be selected by pressing the adjustment buttons and B Heating 1 low power The appliance operates at low power reducing noise levels and energy consumption to a minimum Heating 2 medium power The appliance operates at medium power Heating 3 high power The appliance operates at high power to heat the room rapidly 6 ECO plus function The ECO plus function is available in Heating 1 2 and 3 modes only To activate the function press the ECO plus button D When this function is active the appliance automatically sets the most appropriate power level to guarantee optimum comfort while reducing energy consumption While the ECO plus function is active the appliance may switch automatically to a lower heating power than the one displayed This may happen a number of times in an hour 7 To distribute the air flow over a wider surface press the swing button HE The appliance starts swinging to the right and left To stop the appliance in the desired position simply press the swing button F again 8 To turn the appliance off press the ON STAND BY button A The display may visualize
3. a countdown for about 6 seconds Please note Room temperature can be displayed in either C or F To change the unit of measurement for the tempera ture press the button for a few seconds then release Digital 24 h timer This function can be activated from any operating mode Auto start with the appliance in STAND BY press the timer button E The symbol is displayed together with the time remaining before the appliance comes on To adjust the timer use the adjustment buttons and B then wait a few seconds for the setting to be memorised The stand by light H is displayed together with the symbol indicating that the timer has been set When the programmed time is reached the appliance comes on with the settings used during the previous period of operation Auto off with the appliance on press the timer button E The symbol is displayed together with the time remai ning before the appliance goes off To set the timer use the adjustment buttons and B then wait a few seconds for the setting to be memorised The current settings are displayed again together with the symbol indicating that the timer has been set When the programmed time is reached the appliance goes off automatically To go back to operation without the timer press the timer button E twice The timer symbol disappears from the display Using the remote control The functions on the remote control are the
4. ectly to the mains socket Make sure the appliance is standing upright on a flat surface otherwise the tip over device may be activated Check the temperature and timer settings The appliance may have gone off because the set tem perature has been reached or the time set on the timer has elapsed TECHNICAL CHARACTERISTICS _ Power supply See rating plate Absorbed power
5. liance must not be disposed of with house hold waste but taken to an authorised waste separa tion and recycling centre DESCRIPTION see fig 1 ON STAND BY button adjustment buttons MODE button selects the operating mode ECO plus button Timer button Swing button Remote control receiver Indicator light Air intake grille Filter USE Installation The appliance can be used on any horizontal surface Do not overload the electrical circuit Avoid using the same socket for other appliances r nmo nuu D gt Electrical connection Before plugging the appliance into the mains socket check that the mains power supply corresponds to the value indi cated on the rating plate and that the mains power supply is adequate for the load THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004 108 EEC ON RADIO INTERFERENCE SUPPRESSION Operation and use 1 Plug into the mains socket 2 The appliance emits a beep The indicator light H co mes on and remains lit while the appliance is powered 3 The appliance switches to stand by A dot flashing on the display means the tip over device has been activa ted See paragraph Safety functions 4 Press the ON STAND BY A to turn the appliance on It begins heating the room according to the current set tings 5 Press the MODE button C to select one of the following operating modes Fan 8 Freeze prevention Heating 1 24 a Heating 2 7 a mil Heating 3 2
6. of less than 4m2 Before putting the appliance away make sure it is com pletely off and unplugged from the mains socket Wrap the cable around the base Do not store in dusty atmos pheres Room temperature should be between 0 and 30 C Do not rest anything on the appliance To avoid the safety system resetting accidentally this appliance must not be powered through an external on off device such as a timer or connected to a circuit which is turned off and on regularly by the energy supplier Important safeguards Fry IMPORTANT To avoid overheating never under any circumstances cover the appliance during operation as this would lead to a dangerous rise in temperature Safety functions Safety device the appliance is fitted with a safety device which switches it off in the event of accidental overheating e g obstruction of air intake and outlet grilles motor turning slowly or not at all To reset unplug the appliance from the mains socket for a few minutes remove the cause of overheating then plug in again Tip over safety device a tip over safety device turns the appliance off if it falls over or is positioned inappro priately in such a way as to jeopardise safety The appliance emits a beep and a dot flashes on the di splay The appliance resumes operation a few seconds after being placed in an upright position again Disposing of the appliance In compliance with European directive 2002 96 EC the app
7. same as those on the appliance control panel For a description of the functions see the Operation and use section on the previous page Inserting or replacing the batteries The remote control is powered by a CR2032 lithium battery To operate the remote control pull Close lt and remove the plastic strip under Sk fy the battery cover To replace the batteries remove the battery cover by sliding it as shown in the figure When replacing the batteries make sure you respect the polarity see figure 2 Replace the cover as shown in the figure Old batteries are harmful to the environment and must be removed and disposed of in compliance with current legi slation MAINTENANCE Always unplug from the mains socket before cleaning During the season when the appliance is in use clean the air intake and outlet grilles regularly using a vacuum cleaner To clean the filter remove the rear grille by pulling it outwards fig 1 Remove the dust filter which retains impurities in the air drawn in from the room blow on it lightly then replace in the appliance Never use abrasive powders or solvents to clean the ap pliance Fig 2 Use en TROUBLESHOOTING If the appliance displays PF and emits a beep the tempera ture sensor is malfunctioning If the problem continues contact customer services If the appliance goes off unexpectedly Make sure it is plugged in corr
Download Pdf Manuals
Related Search