Dell W-620 Installation Manual
Contents
1. 0 00 0 00 0 0 aaa S IS e lt o wW Installation in a Server Rack To install a W 620 controller into a 19 inch 48 26 cm Server rack system Note The following instructions describe the installation of your controller in a rack with unthreaded square holes For a rack with unthreaded round holes use the provided clip nuts instead l Place a rack mount bracket over the mounting holes on one side of the controller 2 Secure the bracket to the controller using three M3 6mm x 0 5mm phillips head screws and a suitable screwdriver 3 Repeat these steps on the opposite side of the controller 4 Install the four cage nuts To install the cage nut with a cage nut installation tool a Begin by inserting the lower lip of the cage nut over the bottom of the square opening in the back of the rail b Insert the small end of the cage nut installation tool through the opening in the rail from the front and hook the tool over the top lip of the cage nut c Push the cage nut in towards the rail while rotating the tool up and pulling the tool back toward you until the top lip of the cage nut snaps into position To install the cage nut with a flathead screwdriver a Begin by inserting the lower lip of the cage nut over the bottom of the square opening in the back of the rail b Compress the top lip of the cage nut with a flathead screwdriver c With the lip compressed push the cage nut s lip fully into the openin2. Dell PowerConnect W 620 Rack Mount Installation Guide Introduction The W 620 Rack Mounting Kit provides the means to install a W 620 controller in a standard 19 inch rack The kit includes the following e lx Mounting Tray e 2x Mounting Bracket e 4x M3 x 6mm Screws e 4x M6 x 20mm Screws e 4x Cage Nuts e 4x Cage Clips Installation l Begin by placing the W 620 on the mounting tray figure Ensure that four rubber feet of the W 620 are placed in the four large holes near the corners of the mounting tray K Note Ensure that the side of the W 620 with ports is facing out of the rack This allows for easy access to the ports Figure 1 Mounting Tray Dy Attach the mounting brackets to the mounting tray as shown in Figure 2 a Align the screw holes in the mounting brackets with the mounting posts b Insert and tighten the provided M3 x 6mm screws to secure the mounting brackets as shown in Figure 3 0510782 01 July 2010 Figure 2 Attaching Brackets Figure 3 Controller Secured Installation in a Telecom Rack l Mount the entire assembly to a 19 inch rack as shown in Figure 4 a Align the screw holes on the mounting tabs with those on the rack b Insert and tighten the provided M6x 20mm screws to secure the assembly to the rack 2 Connect all required cables Dell PowerConnect W 620 Rack Mount Installation Guide Figure 4 nstalling the Mounting Kit in a Rack 9 00 000
3. g in the rail d Release the scredriver pressure on the cage nut to lock it into place 5 Mount the controller within your organization s rack system using four M6 x 20mm phillips head screws and suitable screwdriver Dell PowerConnect W 620 Rack Mount Installation Guide 3 6 Connect the AC power cord country specific to the rear of the unit 7 Plug the opposite end of the power cord into an electrical outlet to power the controller 2010 Dell All rights reserved 4 Dell PowerConnect W 620 Rack Mount Installation Guide
Download Pdf Manuals
Related Search