Cooper Lighting RKS140RS-48-10B User's Manual
Contents
1. ack 8 Using self taping loc screws attach retlector to the steel channel cover 9 Snap quarter turn fasteners into holes at each end of the reflector 10 Attach reflector and steel channel cover to the socket brackets using slots in brackets Remove protective film coating and install tamps 12 Re connect power Note Dimensions and specifications may change without notice 8 TEK screw quarter turn fastener self tapping loc screw METALUX P O Box 1207 Amnpricus Geotyin 34709 912 924 ANON Fax 917 974 5507 0318932. RKS 140RS 48 10B amp RKS 140RS 49 10B Installation Instructions Installation instructions for converting two lamp or more industrial and strip type fluorescent fixtures to Rapid Start single lamp 48 and 49 3 4 reflectorized fluorescent fixtures Contents t 48 1 2 or 49 3 4 reflector 1 40 steel channel cover 2 800 URS socket brackets 2 953 lamp holders sockets 4 8 TEK screws 2 quarter turn fasteners 2 self tapping loc screws 2 wire connectors Selecting a ballast When selecting a ballast the fallowing considerations should be made Use only UL Listed Class P thermally protected ballast ft should be suitable for lamps lamp holders type It should not exceed voltage and wattage rating Ballast leads should be of proper length to avoid splicing Primary voltage of ballast should be selected according to supply source voltage 1 Disconnect Power 2 Remove and discard lamps existing channel covers socket brackets and ballast Retain only a bare channel and channel end caps Please dispose of lamps and ballast properly and recycle if possible 3 With bare channel now begin installation of new retrofit kit 4 Prewire lamp holders sockets Insert lamp wire leads of new ballast into 953 RS socket wire terminals This should be completed according to the ballast manufacturer s wiring diagram printed on the ballast label 5 Install ballast with sockets attac
3. hed to leads into channel Make connections of supply wire to ballast using provided wire connectors cooker Cooper Lighting 6 Beginning at one end of the channel install appropriate pre wired socket into first 800 URS bracket Using 8 TEK screws attach the bracket flush with the end of the fixture channel h WARNING Risk of fire or electrical shock Reflector kit installation requires knowledge of fluorescent lighting fixture electrical systems If not qualified do not attempt installation Contact a qualified electrician SSI WARNING To prevent wiring damage or abrasion do not expose wiring to edges of sheet metal or other sharp A objects Reflector kit is not intended to be used for damp or wet lacations WARNING Risk of fire or electrical shock Fixture wiring ballast or other electrical parts may be damaged when OES drilling for installation of reflector kit hardware Check for enclosed wiring and components WARNING Do not make or alter any open holes in an enclosure of wiring or electrical components during kit A installation 7 Using steel channel cover as a spacing jig place opposite bracket in ook place and attach with 8 TEK screws eee N Spacing between brackets is 40 4 1 4 channel Note When converting an 8 section of fixture feed the remaining two pre wired 953 sockets above the bracket Repeat steps 6 and 7 placing center two brackets back to
Download Pdf Manuals
Related Search