Coleman 9232C379 User's Manual
Contents
1. Coleman When You Are Ready To Set Up Your Tent Select a level campsite clear of rocks branches and other hard or sharp objects Do not set up your tent under trees For best results in windy conditions position the end of tent into the wind Layout amp Positioning of Tent Layout and position tent with screen room facing desired direction illus 1 Stake down tent starting with the corners Do not stretch too tight Angle the stakes slightly toward the tent illus 2 Keep the floor taut Stake down the remainder of the stake loops Unzip the door SCREENED WEATHERM ASTER 17X9 Instructions apply to Part Number 9232C379 POLE ASSEMBLY PARTS 3 Center Curved Roof Poles Red Sticker Part No 9232C372 1 Rear Blue Sticker Part No 9232C373 2 Rear Brace Poles ee Blue Sticker Part No 9232C375 eea ee 6 Center Upright Poles eS Red Sticker Part No 9232C374 Rainfly Part No 9232C371 N illus 2 Stake loops properly staked Roof sleeve Front of screen door illus 1 Assemble amp Place Roof Poles Assemble all shock corded Forms an arch roof poles When assembled will form a continuous arch with both ends pointing down illus 3 Select center roof poles with Shock corded poles illus 3 Curved roof pole assembly red stickers then insert through the two center roof sleeves and the r2. brace poles to the curved poles make sure that the brace poles naturally point straight down Brace pole I illus 5 Shown with both center brace poles in position and curved poles through center pole sleeves illus 8 Insert squeeze pin into pole illus 9 Tent shown completely set up Note the different angles of the end brace poles Things You Should Know Under certain conditions cold weather high humidity etc condensation will form on the inside surfaces of your tent Condensation is caused by water vapor from your breath perspiration or any wet clothing inside your tent It is NOT LEAKAGE through the tent fabric It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent Never store tent even for a short period of time without drying it thoroughly and brushing off caked dirt Do not pack stakes or poles inside your tent Use a separate storage bag STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE Seam sealer has not been provided with your tent For additional protection we recommend seam sealing your tent prior to camping Seam sealer may be purchased through your local retailer or at your local sporting goods store PRINTED IN SRI LANKA Rev 7 04 Do not leave your tent set u
3. oof pole sleeve at the front of the screen room illus 4 Select end roof pole with blue sticker then insert through the roof sleeve at end of the tent illus 4 Roof pole sleeve illus 4 Curved roof pole system shown inserted through pole sleeve Raise Center of Tent Assemble center shock corded brace poles red sticker longer poles Pole should be initially adjusted to the inner most hole A illus 7 Insert square end of brace poles into curved roof poles and raise tent upright illus 5 6 7 Brace poles should attach to squeeze pins at bottom of tent illus 8 Repeat for brace poles at front of screen area C illus 7 Poles should be initially adjusted to the inner most hole A Raise Ends of Tent Assemble end blue sticker round ends shock corded brace poles Insert blue sticker brace poles into end roof assemblies MAKE SURE when attaching the brace poles to the curved poles that the bottom of the brace pole naturally points down and toward the center of the tent illus 9 Brace poles should attach to squeeze pins at bottom of tent illus 8 Adjust poles to accomodate for terrain Drape rainfly over tent covering the center and end poles sleeves Attach S hooks on rainfly into holes in brace poles illus 9 Curved poles in pole sleeve Rainfly hooks to brace poles illus 6 When attaching the
4. p for weeks at a time be aware that exposure to the ultraviolet rays of the sun can seriously damage material and or cause it to become discolored WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC This tent meets the flammability requirements of C PAI 84 T he fabric will burn if left in continuous contact with any flame source T he application of any foreign substance to the tent fabric may render the flame resistant properties ineffective Coleman THE COLEMAN CO INC 3600 N Hydraulic e Wichita Kansas 67219 1 800 835 3278 www coleman com MADE IN SRI LANKA
Download Pdf Manuals
Related Search