Coleman 2000004414 User's Manual
Contents
1. Make sure all components are clean and dry before placing in carry case 3 Store in a clean dry area The Coleman Company Inc e 3600 North Hydraulic e Wichita Kansas 67219 1 800 835 3278 in the United States e www coleman com MADE IN CHINA PRINTED IN CHINA 2009 The Coleman Company Inc All rights reserved Coleman AAE and are registered trademarks of The Coleman Company Inc 4010005765 20091125 STITCH LINE2. SCREENHOUSE SETUP INSTRUCTIONS MODEL 2000004414 Before you begin Raise the Screenhouse Read all instructions before set up e Extend each of the telescoping leg poles until they snap e Select a level site clear of rocks branches and other hard or into place The screenhouse will raise as the leg poles are sharp objects to install your screenhouse extended Fig 4 Ay WARNING Keep clear of overhead power lines e Do not set up your screenhouse under trees because of potential lightning strikes or falling tree limbs in inclement weather e Secure with all stakes and guylines provided to prevent property damage or personal injury e For best results in windy conditions position narrow end of screenhouse into the wind e Do not drop screenhouse e Do not bounce screenhouse bag on its end to remove screenhouse as these actions may damage the frame e THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO PEOPLE TO ASSEMBLE e Under no circumstances should this product be used to cover automobiles marine products or similar items CAUTION Avoid pinch points when opening and closing the screenhouse frame Stake the Screenhouse e Secure screenhouse by driving stakes through the webbing loops sewn to the screenhouse base Fig 5 and Fig 6 Extend the Screenhouse e Keep the floor taut Frame e Stand the screenhouse upright with the hub assembly at the top Fig 1 e Unfold the arms of the screenhouse downward until they l
3. ay flat on the ground Fig 2 a A e Extend the arms of the screenhouse away from the center f hub Fig 3 apapa Webbing Loop Fig 6 continued on other side Secure the Guylines e Attach and stake out guylines Fig 7 and Fig 8 e Adjust sliders to make guylines tight Fig 8 Things You Should Know Under certain conditions cold weather high humidity etc condensation will form on the inside of your shelter Condensation is caused by water vapor from your breath perspiration or any wet clothing inside the shelter It is NOT LEAKAGE through the shelter fabric Tree limbs tree sap bird droppings or moisture steadily dripping off tree limbs can cause damage to the shelter fabric and its coating resulting in leaks or loss of flame resistant properties Never store screenhouse even for a short period of time without drying it thoroughly and brushing off caked dirt Do not pack stakes inside your screenhouse Use a separate storage bag Stakes should be removed by pulling on the stake itself NEVER PULL ON THE SCREENHOUSE TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY Do not leave your screenhouse set up for weeks at a time Be aware that exposure to ultraviolet rays from the sun can seriously damage material and or cause it to become discolored This product is not intended to be used during heavy rain wind hail snow or other inclement weather Exces
4. s water build up can cause the frame system to be come unstable and possibly collapse Causing injury The screenhouse should be taken down and placed in storage during windy conditions to avoid damage to product or personal injury DO NOT use gas or flame sources under or near this product WARNING Keep all flame and heat sources away from this tent fabric This tent meets the flammability requirements of CPAI 84 The fabric may burn if left in continuous contact with any flame source The application of any foreign substance to the tent fabric may render the flame resistant properties ineffective Disassembly To take down the screenhouse follow the previous steps and illustrations in the reverse order e Remove guylines and stakes Fig 7 and 8 e Lower the frame one leg pole at a time by pushing the lock buttons and collapsing the telescoping leg poles Fig 4 e Retract the arms of the screenhouse toward the center hub Fig 3 e Collapse the screenhouse by folding the arms upward until the screenhouse stands upright with the hub assembly at the top Fig 1 e Place the screenhouse in the carry bag for storage TIP After collapsing the screenhouse place it on its side then roll it multiple times with pressure to reduce its size This will allow the unit to slip into the carry bag To Store 1 All stakes must be placed in the storage bag to prevent damage to the fabric items placed in the Carry case 2
Download Pdf Manuals
Related Search