Casio Watch MA0504-EA User's Manual
Contents
1. Adjusting the Stopwatch Second and Minute Hand Positions Use of the stopwatch can cause the starting positions of the stopwatch minute hand and second hand to become misaligned Use the following procedures to check hand alignment and to adjust the positions of the hands so they point to 12 o clock when the stopwatch is reset To adjust the positions of the stopwatch hands 1 Press to reset the stopwatch and check the alignment of the stopwatch minute hand and second hand Pull out the crown to the second click Press to move the stopwatch second hand forward until it points to 12 o clock If the stopwatch minute hand is aligned correctly proceed to step 5 If the stopwatch minute hand is also misaligned press 8 so the stopwatch minute hand jumps to 0 5 After making the adjustments you want push the crown back in to its normal position e Note that pulling the crown out also stops the timekeeping second hand After performing the above procedure you should also adjust the timekeeping setting For watch with the elapsed time bezel Rotate the elapsed time bezel to align the 7 mark with the minute hand After certain amount of time elapsed read the graduation on the elapsed time bezel which the minute hand points to The elapsed time is indicated p Elapsed time bezel e Some water resistant models are equipped with a screw lock crown e With such models you must unscrew the crown in the direction noted2. in the illustration to loosen it before you can pull it out Do not pull too forcibly on such crowns Also note that such watches are not water resistant while their crowns are loosened Be sure to screw the crowns back in as far as they will go after making any setting
3. MA0504 EA Operation Guide 4333 CASIO Stopwatch minute hand To set the time 1 Pull out the crown to the second click a Fr rst click a causes the second hand to tti i Day setting 2 Set the hands by rotating the crown b s 9 Move the minute hand four or five Hour hand Minute hand B minutes past the time you want to LT ON Iy set and then back it up to the proper CANA Second click setting WW Time setting 3 Push the crown back in to the normal position to restart timekeeping Crown hand Normal position To set the day 1 Pull out the crown to the first click 2 Set the day by rotating the crown 3 Push the crown back in to the normal position e Avoid setting the day between 9 00 p m and 1 00 a m the day display may not change in the following day Using the Stopwatch The stopwatch lets you measure elapsed time up to 59 minutes 59 seconds You can also correct the position of the stopwatch second hand when necessary e The illustration shows a time of 20 minutes 40 seconds e Do not try to perform stopwatch operations while the crown is pulled out either to the first or second click If you try to press a button you might accidentally cause the crown to rotate and change the current time or day setting To measure elapsed time 1 Press to start the stopwatch 2 Press to stop the stopwatch e You can resume the measurement operation by pressing again 3 Press to reset the stopwatch
Download Pdf Manuals
Related Search