Bennett Marine ES2000 User's Manual
Contents
1. EUROSTYLE ROCKER SWITCH CONTROL Part ES2000 INSTALLATION INSTRUCTIONS 1 Before you drill any holes read the entire instruction sheet 2 Unsnap the bezel from the control Using the bezel locate the position for the control at the helm Check carefully to make sure there are no obstructions behind the dashboard before drilling any holes 3 The bezel requires a footprint of 2 13 16 x 2 7 64 Pilot 13 16 Cut a 2 1 2 hole in the center of the Yellow Hole footprint using a hole saw 4 Pull the wire harness up through the hole and attach it to the back of the control with the ring terminals enclosed Please make sure that the gasket is in place with the flat side down before attaching wires to the control There are two screws foreach Red wire The wire can be attached to either screw The brass strip is marked with the first letter of that color of the wire All 12 screws must be in place and snug for proper control function 5 Mark the four locations for the 7 64 pilot holes and drill Test fastening with the 8 screws Open the holes to 1 8 if necessary 6 Place the wire harness and switch in the hole with yellow connections at top Secure the switch plate assembly with the enclosed 8 screws Be sure the switch is properly seated and snap bezel onto switch plate assembly Note Bezel will secure completely when BOW DOWN is at top and switch plate assembly is mounted with top and bottom in proper position wit2. h yellow connections at top Blue Pump pressure trim tabs down Yellow Pump retract trim tabs up Red Port valve Green Starboard valve Orange with 20 Amp Fuse 12 volts positive The above wiring is recommended If the operator prefers different action from the control and tabs it can be changed as desired Bennett Marine 550 Jim Moran Blvd Deerfield Beach FL 33442 Phone 954 427 1400 Fax 954 480 2897 www Bennetttrimtabs com info BennettTrimTabs com
Download Pdf Manuals
Related Search