BEA Spotfinder Infrared Zone Locator User's Manual
Contents
1. Page 1 of 2 Shut off all power going to work area before attempting any wiring procedures Maintain a clean amp safe environment when working in public areas Constantly be aware of pedestrian traffic around the area Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions by the door O oO O UD DU Always check placement of components before powering up so that moving parts will not catch any wires or cause damage to equipment m Ensure compliance with all applicable safety standards i e ANSI A156 10 19 upon completion of installation 4 DO NOT attempt any internal repair of the components All repairs and or component replacements must be performed by BEA Inc Unauthorized disassembly or repair 1 May jeopardize personal safety and may expose one to the risk of electrical shock 2 May adversely affect the safe and reliable performance of the product resulting in a voided warranty Avoid long exposure to bright Keep the IR SPOT and LED lenses clean Before long storage remove batteries sunlight and or moisture to prevent battery acid damage 5 Battery Replacement 1 5 VOLT AAA BATTERIES LR03 Remove two screws from back of Spotfinder 2 Separate housing and install a two fresh 1 5 Volt AAA Type LRO3 batteries making sure to observe proper polarity 3 Reassemble housing and replace screws NOTE Don t throw used batteries away with2. OPEN UP NE ONS A HALMA COMPANY 75 0176 04 20080331 SPOTFINDER USER S GUIDE INFRARED ZONE LOCATOR Description amp Specifications BEA s Infrared IR Spotfinder is a hand held tool used to locate an active infrared source This easily locates an IR area which can be used to assist in the palcement of the sensing zone as well as approximate the distance from a sensor The Spotfinder has two settings 1 LED only light no sound or 2 LED and Buzzer This accessory will shut off after 45 seconds of no IR activity To reactivate switch OFF then back ON by selecting either LED or BUZZER POWER SUPPLY AAA Alkaline Batteries 2 Included DIMENSIONS 3 X 2 1 4 X 1 76mm x 57mm x 25mm MATERIAL ABS Plastic Settings amp Placement For sliding door overhead presence detection place the Spotfinder flat on the floor so that the IR SPOT is at the appropriate distance from the door face Adjust the IR Curtain on the sensor until the LED turns Orange and or the Buzzer begins to beep as in Position 2 below NOTE The Spotfinder only serves to identify an area of infrared light and not necessarily imply the area of the sensors detection BEA Inc always recommends a walk test to ensure compliance to all applicable standards for sensing patterns GREEN LED FOR POSITION See ANSI A156 10 for Required Distance ae SOFT WEAK LOUD STRONG LOW BATTERIES
3. the general trash Discard per your local municipal laws and regulations 6 Company Contact A HALMA COMPANY a problem please call BEA Inc If you must wait for the following workday to call BEA leave the door inoperable until satisfactory repairs can be made Never sacrifice the safe operation of the automatic door or gate for an incomplete solution The following numbers can be called 24 hours a day 7 days a week i Do not leave problems unresolved If a satisfactory solution cannot be achieved after troubleshooting For more information visit www beasensors com US and Canada 1 866 249 7937 Southeast 1 800 407 4545 Canada 1 866 836 1863 Midwest 1 888 308 8843 Northeast 1 866 836 1863 West 1 888 419 2564 Page 2 of 2 75 0176 04 20080331
Download Pdf Manuals
Related Search