Attwood 91022 User's Manual
Contents
1. light specs to protect the circuit MAKE SURE POWER SOURCE IS 12 VOLT D C ONLY HIGHER VOLTAGE CAN CAUSE DAMAGE TO LIGHT AND WIRE CIRCUITRY Insert light pole into base and press down to make contact Insert lock collar into base opening rotate if necessary to push it down into base Rotate collar until tight to hold light pole in base Test light operation Remove and stow light Close cover to protect contacts when not in use Part 91020 91021 Part 91022 This product carries the standard Attwood one year limited warranty See product catalog for details 2003 Attwood Corporation 1016 N Monroe Street Lowell MI 49331 0260 www attwoodmarine com2. Plastic Stowaway Light Base 91020 91022 2 wire 91021 3 wire Installation Instructions Attwood marine hardware navigational lighting bilge pumps and other marine accessories are specified more than any other brand by America s best known boat manufacturers as original equipment Look to Attwood for quality replacement parts and marine accessories SAVE THESE INSTRUCTIONS Form Number 69345 Rev C 03 12 FEATURES This base is designed for use with the Attwood 3900 Series All Round Lights And Attwood Combination Sidelights For 12 volt D C only CAUTION To prevent personal injury always disconnect the power source when installing or servicing this product Always remove the boat from the water before using 120 VAC power tools INSTALLATION INSTRUCTIONS Note For technical detailed positioning follow COLREG 72 or ABYC A 16 Below is a simplified drawing of placement of navigational lights in relationship to one another Figure 1 Figure 1 1 Position the light base either on the bow for combination sidelights or the stern or gunwale for all round lights Be sure that the mounting surface is flat and that the selected area will accommo date the base dimensions Base angle and position must properly place light used in base 2 Using the template provided locate the base center line parallel to the boat fore and aft center line and carefully mark the center installation hole and the screw hole
3. s Drill 1 3 8 diameter hole for 91022 or 1 1 4 diameter hole for 91020 and 91021 being very careful not to crack or break the gelcoat finish and sand to remove burrs from around the edge of the hole Drill the pilot screw holes Figure 2 Note On some installations you may have to connect the wires then push them back through wire hole prior to screwing down the base 3 Apply sealant between deck and light base Fasten base in place with stainless steel screws CAUTION Do not overtighten screws Figure 2 3 4 gt x 1 1 3 4 1 3 8 i O ce Oval Template gt 15 32 lt lt 15 16 gt Sot 1 Na Forward e 1 1 2 gt lt 3 4 gt i ry A 27 32 1 1 4 1 1 4 y v Round Template Forward FINAL WIRING FOR 91020 91022 2 wire base Connect one black wire to the battery ground harness using a crimp on wire connector Attach the remaining black wire to the positive switched wire from the navigation light switch 91021 3 wire base Connect black wire to the battery ground harness using a wire connector Connect the blue wire to the wire from the switch for the courtesy light Use a wire connector to make the connection Connect the gray wire to the wire from the switch for the navigation running lights using a wire connector All positive wires must be fused according to
Download Pdf Manuals
Related Search