Ariston ARH6SIX User's Manual
Contents
1. ARISTON USER MANUAL ARH6SIX IMPORTANT Please ensure that you read through this user manual prior to installation and use This manual contains important information to ensure optimal performance and keep you safe Please retain your proof of purchase as this will be required in the event that you require warranty service Remember to retain this manual for future reference a www aristonbrand com P s HELLO CONGRATULATIONS ON THE SELECTION OF THIS ARISTON APPLIANCE ARISTON APPLIANCES HAVE BEEN SPECIFICALLY DESIGNED FOR AUSTRALIAN AND NEW ZEALAND KITCHENS Please read through this user manual carefully as it contains information that will ensure that your appliance is installed correctly important operating amp care instructions and also some advice of what you need to do if this appliance is not performing as intended www aristonbrand com ARISTON a AN D 6 CONTENTS HELLO CONTENTS WARNING amp SAFETY INFORMATION INSTALLATION amp DUCTING OPERATING INSTRUCTIONS MAINTAINING YOUR RANGEHOOD PRODUCT SPECIFICATION PROOF OF PURCHASE 10 NOTES 11 CONTACT DETAILS 12 O O IN O AR O ID a ARISTON www aristonbrand com k lt amp w J S 6 WARNING amp SAFETY INFORMATION This appliance is not intended for use by persons including children with reduced physical sensory or mental C2. re circulating carbon filters must be installed This Unit is pre installed with a carbon filter WARNING DO NOT penetrate any screws Into the range hood as this may result in electrical hazards WARNING Failure to install the screws or fixing device In accordance with these Instructions may result in electrical hazards NZ PS N FRONT RE CIRCULATING Carbon filter required TOP DUCTING OPERATING INSTRUCTIONS LOW OFF HIGH IMPORTANT To operate the unit single line indicate low speed double ensure that the power is turned on and lines indicate the high speed the front visor is fully extended This will provide access to the light and speed controls To tum the unit off you can either slide the visor into the closed position or set the speed switch to the middle position off FAN SPEED LIGHT LOW OFF HIGH switch located on the right hand side of the unit On Off switch located on the left hand side of the unit as indicated in the This unit features 2 speed settings diagram above a ARISTON www aristonbrand com S 6 MAINTAINING YOUR RANGEHOOD GENERAL MAINTENANCE Ensure that the power to the unit is switched off prior to cleaning the unit Surface should only be cleaned with warm soapy water and a soft non abrasive cloth In coastal environments and humid areas more frequent cleaning is required to maintain the finish FIL
3. TERS This unit is supplied with a carbon filter designed to eliminate odours from you exhaust fumes This filter cannot be cleaned and should be replaced every 3 6 months dependant on use Aluminium filters may be ordered from your nearest service centre for ducted installations Aluminium filters are dishwasher safe or can be cleaned with hot soapy water Ensure that filters are thoroughly dry before re installing LAMPS Your range hood is fitted with GU10 halogen lamps Before replacing ensure that lamps are completely cool and the power to the unit has been switched oft Replacement lamps can be purchased from your nearest service centre To remove the lamp twist the lamp in an anti clockwise direction Be careful when installing the new lamp not to make contact with the skin as this may damage the lamp and shorten its life www aristonbrand com ARISTON a NZ PS N PRODUCT SPECIFICATION E 5 eee ee A KT 0 oes a ARISTON MODEL ARH6SIX SERIAL 220 240V 50Hz Lights 2 x 40W Max Total 200W Motor 120W JA E Www aristonbrand com Made in PRC For service please call Australia 1300 815 589 m C N New Zealand 09 306 1020 5364 L m e a ARISTON www aristonb
4. apabilities or lack of experience and Knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Young children should be supervised to ensure that they do not play with the appliance There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels You must read the details concerning the method and freguency of cleaning There is a fire risk if cleaning is not carried out in accordance with the Instructions Do not flambe under the rangehood Exhaust air must not be discharged into an existing flue which is used for exhausting fumes from appliances burning gas or other fuels www aristonbrand com ARISTON a The minimum distance between the hob surface and the lowest part of the rangehood is 600mm This distance shall be at least 650mm if the rangehood is installed over a gas hob If the instructions for the gas hob specify a greater distance this has to pe taken into account Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air is tulfilled If the supply cord of this eguipment is damaged it must only be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard This appliance has been designed for indoor domestic use only Do not remove or inspect t
5. he filters whilst the hood is in operation NZ PS N INSTALLATION DUCTING TO SS SS SS S SS SSS EA ET SS S TA Se S eS Y SS Se SS EH SS S SS SS SS M A Sa SS SS SS SS S ye Se Ss SSS 10A plug fitted NOTICE All measurements shown are to be used as a guide only cutout dimensions should be taken from physical product r j r eer EE EEE IMPORTANT Before handling the rangehood olo during installation it is recommended that you remove the filter to prevent damage Fig 1 2 illustrates the minimum height from the hob Mitan n surtace to the underside of the rangehood Electric Electric Hob 600mm hob 600mm Gas hob 650mm Gas Hob 650mm NOTICE IF THE INSTRUCTIONS FOR THE GAS HOB SPECIFY A GREATER DISTANCE THIS HAS TO BE OBSERVED ANY INSTALLATION ABOVE 750MM WILL COMPROMISE PERFORMANCE 1 FIG12 am m m m jn mm nj n l p gt m m mm n s m mn Vl a ARISTON www aristonbrand com INSTALLATION amp DUCTING Ca a a Sa a mt mmm ca ce a a a ce mm a yh aN is mts mi a a a ce a ae irti DUCTED BT s Ne Co FR m n em do k R S S A RT DUCTED OPTION 1 Remove the filter 2 Optional replace the 65mm front rail with the 45mm front rail inc in box 3 Make sure that internal switch is in ducted position see above 4 Determine the most efficient path for the ductwork minimise bends and keep the length of
6. rand com k PROOF OF PURCHASE ATTACH YOUR PROOF OF PURCHASE FOR FUTURE REFERENCE www aristonbrand com ARISTON a NOTES a ARISTON www aristonbrand com k 6 VERSION 1 0 CONTACT DETAILS AUSTRALIA ARISIT PTY LIMITED 40 44 Mark Anthony Drive Dandenong South VIC 3175 Australia Ph 1300 815 589 FX 03 9768 0838 consumer care arisit com NEW ZEALAND ARISIT PTY LIMITED PO Box 68 140 Newton Auckland 1145 New Zealand Ph 09 306 1020 FX 09 302 0077 sales aristonappliances co nz EVERY EFFORT HAS BEEN MADE TO ENSURE ALL INFORMATION IN THIS USER MANUAL IS CORRECT AT TIME OF GOING TO PRINT DIMENSIONS SHOULD BE USED AS A REFERENCE ONLY AND ACTUAL DIMENSIONS SHOULD BE TAKEN FROM THE PHYSICAL PRODUCT ONLY MANUFACTURER RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE a aristonbrand com A ARISTON
7. the ductwork to a minimum 5 Before fixing the range hood drill a hole to accommodate the 120mm ducting that you have selected 6 It is important to run and finish install roof wall caps prior to installation of the hood 7 Ensure that access has been allowed for the power cable and plug after Installation 8 Removethe 120mm ducting cover plate and attach the ducting adaptor 9 Holdthehood up to the underside of the cabinet Screw the rangehood to the underside of the cabinet Ensure that you do not damage any of the wiring during installation 10 Attach the ducting adaptor to the ducting 11 Re install filter 12 Plug in the power to the unit turn on and test www aristonbrand com ARISTON a RECIRCULATED Can ha et ay e SKS E S a S m n AM A A k AX sta hl RE CIRCULATING OPTION Remove the filter 2 Remove the front sealing tape to expose the front vents Do not remove the top 120mm outlet cover 3 Make sure that internal switch is in recirculating position see above 4 Drill 4 fixing holes as per the drawing Ensure that access has been allowed for the power cable and plug 5 Hold the hood up to the underside of the cabinet align the 4 holes in the cabinet with the corresponding holes in the hood Screw the 4 screws from the cabinet side Re install filter 7 Plugin the power to the unit turn on and test A O Notice When the rangehood is
Download Pdf Manuals
Related Search