American DJ H2O User's Manual
Contents
1. American AHO User instructions Caution Please read and follow all instruction before attempting to operate this or any other electrical unit Technical Specifications Model H20 Lamp JCR H5 15V 150W Voltage 110 120v Dimensions 13 75 x 5 75 x 13 75 Colors 9 White Weight 19 Lbs Fuse 2Amp GMA Duty Cycle 15min on off H20 Introduction Congratulations and thank you for purchasing the American DJe H20 This fixture is designed to operate as a stand alone unit It has been tested and lamped at the factory there is no assembly necessary The H2O was created to meet the demands of theatrical groups and production groups The desire was to create a low cost unit with an incredible effect without any strong flashing lights or special fog needs When used with the internal clear gel this unit creates the effect of rippling water movement or use the internal orange gel to create a dramatic fire simulation This unit comes with 9 built in colors that can be used to create a variety of different and unique effects H20 Functions and Controls Simplicity at it s beast this fixture is ready to be plugged in right out of the box there is no assembly required The unit s two internal wheels will immediately begin to turn when power is applied On the rear of the unit there is one toggle switch that is used to control the internal color wheel You may leave the color wheel on and it will continuo2. usly rotate through all the colors To create a single color effect let the color wheel rotate until it reaches your desired color and then turn the color wheel switch to the off position You may also create a more dramatic effect by use split color combination by stopping the wheel anywhere between two adjacent colors This unit is not sound activated so there is no need for an audio source There is no power switch after plugging the unit in if there is no lamp output check the fuse and bulb If the fuse and bulb are good please return the unit to your dealer for servicing H20 Lamp Replacement Disconnect the unit s main power supply Remove the thumb screw on the top of the unit Remove the trap door Carefully remove the old bulb from the unit Be sure the unit has had ample time to cool before attempting to replace the lamp Carefully install the new lamp follow all the installation guide lines that are included with your new lamp Replace the trap door and thumb screw Caution Always replace with the exact same type lamp and fuse unless otherwise specified by an authorized American DJe technician American DJ Supply Inc Los Angeles Ca 90058 USA www americandj com H20
Download Pdf Manuals
Related Search